







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Jerith Driveway & Pavers: The Downey Owner’s Guide
We install and repair Jerith-compatible driveway and paver systems across Downey, and most full paver driveway installations here run $7,000 to $18,000; targeted repairs are far less. Jerith makes ornamental fencing and gate systems, so a paver or driveway project that lands on a Jerith page is almost always about a gate, pillar, or border component at the driveway apron that ties into the hardscape. Owners usually find the problem the same way: a gate sags and drags on the pavers, a post at the driveway edge leans after a wet winter, a paver border heaves and pops the gate frame out of alignment, or the swing no longer latches because the ground under one post has settled. In Downey, that pattern shows up most on driveways that meet the alley or street apron, where runoff does the quiet damage.

Which Jerith Models This Applies To
Jerith’s ornamental lines are sold by series and height, and the part that matters at a driveway is usually the post, hinge, latch, or post-mount hardware rather than the panel itself. Identify your gate before ordering anything: look for the fabricator label stamped on the bottom rail or inside the post cap, measure the post height from the paver surface (not from bare dirt), and note the rail spacing. Panels come in standard heights, and a replacement post that’s an inch short or a hinge set drilled for a different rail gauge won’t line up. On the OEM-versus-aftermarket question, Jerith-specific hardware costs more but keeps the swing geometry and finish consistent with the rest of the run. Generic hinges and latches fit, sometimes, and then fail early because the gauge and hole spacing are off. We work as an independent contractor in Downey and aren’t affiliated with Jerith, so we match parts by measurement and spec, not by assuming.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Jerith Driveway & Pavers Is Failing
- Gate drags or scrapes the pavers. A hinge has worn or a post has settled a fraction of an inch, and the gate now rides low enough to catch the surface.
- Post leans after rain. Water pooling at the driveway apron softens the base, and the post shifts. In Downey’s clay-heavy soils, this shows up fast after a wet season.
- Latch won’t catch. The gate has dropped out of square, usually because the post on the hinge side moved or the hinge pin is worn.
- Pavers heave or separate at the border. The border course that frames the gate opening is lifting, which throws off the gate’s footing and alignment.
- Rust bleeding at the base or hardware. Standing water at the apron is the culprit, and the finish failure tells you the drainage needs attention, not just the part.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Downey, a full paver driveway installation runs $7,000 to $18,000, and a concrete driveway $4,500 to $12,000. If the real issue is at the gate hardware and base, expect targeted repair rather than a full driveway. What drives the range: square footage, whether the existing surface has to come out, base depth and drainage correction, and the pavement pattern. Our quotes are line-item and upfront – the number you see is the number you pay, no change-order surprises. The work carries our 730-Day Done Right Promise: if it’s not done right, we make it right. Financing at 0% for 18 months is available, and projects over $10,000 get $1,000 off.
DIY or Call Us?
You can safely check a few things: measure the post height, look for the fabricator label, test the latch, and photograph the base for water pooling. Where DIY goes wrong is resetting a post or relaying the paver border at the apron. If the base isn’t corrected, the new post leans within a season, and you’ve spent the money twice. The same goes for drainage – the fix is under the surface, not at it. Call (888) 255-8179 and we’ll tell you straight whether it’s a hardware swap or a base repair. Live person, 24/7, free estimate.
FAQs

How long does a Jerith gate post or driveway border last in Downey? With a solid base and drainage, hardware and posts hold up a decade or more; the weak point is the base, not the metal. Call (888) 255-8179 for an exact assessment – estimates are free.
Can it be repaired instead of replaced? Often yes. A worn hinge or latch is a small swap; a leaning post needs the base corrected, which is a repair, not a replacement. We quote both so you can decide.
How long does the swap take? A hardware or latch swap is typically a single visit. A post reset or border repair usually takes longer once the base is opened and corrected.
How do you source the part? By measurement and spec – series, post height, rail gauge, and hole spacing – matched to your existing gate. We don’t stock parts on a truck; we source what fits and install it right.
We also service Kitchen and bath brands like KraftMaid, Cambria, and Silestone for Downey homeowners planning a larger remodel. Call (888) 255-8179 for a free estimate.
Written by the team at Groundwork Construction Co. of Downey, serving Downey and nearby areas.












