







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Unilock Roofing: The Downey Owner’s Guide
If your Unilock roof is leaking, cracked, or past its service life, a full roof replacement in Downey typically runs $8,000 to $20,000 installed, while a targeted roof repair falls between $400 and $1,800. Unilock is a premium concrete tile line, so most Downey owners discover the failure at the same few points: a cracked tile after a hot, dry summer, a leak stain blooming on a ceiling near a valley, or a ridge cap that’s shifted loose after a Santa Ana wind event. Once you see water where it doesn’t belong, the clock starts – a small tile issue becomes deck rot fast in Southern California’s dry-wet swing.

We install and repair Unilock roofing across Downey, and we’re an independent contractor, not affiliated with Unilock. What follows is the parts-and-replacement picture you actually need before you call anyone.
Key Takeaways
- Unilock concrete tile failures in Downey usually trace to heat cycling, wind uplift, or failed underlayment – not the tile itself.
- Single-tile swaps are the cheapest fix; underlayment failure means pulling field tiles, which changes the price fast.
- Most tile repairs can be completed in a single visit. Full re-roofs run several days depending on square footage and pitch.
- All our work is covered by the 730-Day Done Right Promise.
Which Unilock Models This Applies To

Unilock’s concrete roof tile lines use profile-specific interlocking edges, which means a replacement tile has to match not just color but the exact profile and dimension of the field. Two tiles can look identical from the street and still not seat together – the wrong profile leaves a gap that a wind-driven rain will find. Before you order anything, check the original roofer’s paperwork or look for the profile stamp on the back of a broken tile; if neither exists, we measure the exposed tile length and width on your roof and match the profile physically.
The OEM-versus-aftermarket decision matters here. Unilock’s own replacement tiles give you an exact profile and color match, but discontinued colors are common on roofs installed more than 15 years ago. A quality aftermarket concrete tile in a matching profile works fine structurally and costs less, but the color will read slightly different in Downey’s strong afternoon sun. We tell homeowners plainly which route matches their roof, and we don’t order parts until the profile is confirmed in person.
Some Downey roofs mix Unilock field tile with other manufacturers’ ridge caps and trim. That’s fine – it just means the trim and the field have to be sourced and matched separately.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Unilock Roofing Is Failing
- Hairline cracks spidering across tiles. Thermal cycling – Downey’s 100°F summer days dropping to cool nights – stresses concrete tile over decades. Cracks let water past the surface and into the underlayment.
- Ceiling stains or attic moisture after rain. This almost always points to failed underlayment, not the visible tile. The tile sheds most water; the underlayment underneath is the real waterproofing layer.
- Loose or shifted ridge caps. Santa Ana winds routinely peel ridge and hip caps that were fastened lightly. A shifted cap is a direct water entry point at the roof’s most vulnerable edge.
- Granules and tile dust in gutters. Shedding surface material signals tile age. Fine dust is normal early on; heavy grit after 20 years means the tile is near end of life.
- Sagging or soft spots on the deck. This is rot. It means water has been getting through for a while, and it turns a $600 tile repair into a deck rebuild if you wait.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s the honest Downey pricing for Unilock tile work:

| Job | Installed Price Range |
|---|---|
| Roof repair (tile swap, flashing, small leak) | $400 – $1,800 |
| Tile roof repair (larger sections) | $600 – $2,500 |
| Full roof replacement | $8,000 – $20,000 |
What drives the range: how much tile has to be pulled, roof pitch, whether underlayment is replaced, and access. Parts and labor are quoted together in a written line-item estimate – you’ll see the tile, the underlayment, and the labor as separate lines. No-hassle upfront pricing means the number you see is the number you pay, and the work carries our 730-Day Done Right Promise.
DIY or Call Us?
You can safely inspect from the ground with binoculars and check attic sheathing for moisture after a rain. That’s the ceiling of safe DIY here. Climbing a Downey roof to swap tile is where it goes wrong – concrete tile is heavy, the pitch is often steeper than it looks, and walking on it without the right technique cracks the very tiles you’re trying to save. Underlayment work and deck repair are flat-out professional jobs. If you see ceiling stains, soft deck, or repeated leaks, get it looked at rather than testing it yourself.
Call (888) 255-8179 for a free estimate – a live person answers 24/7, and we’ll confirm your Unilock profile and give you a written number before any work starts.
FAQs

How long does Unilock roofing last in Downey? A well-installed Unilock concrete tile roof lasts 40 to 50 years, but the underlayment beneath it typically needs replacement at 20 to 25 years. In Downey’s heat-and-dry cycle, underlayment is what usually fails first, not the tile.
Can a damaged Unilock roof be repaired instead of replaced? Yes, if the damage is isolated to a few tiles or a flashing point, a targeted repair in the $400 to $1,800 range solves it. If underlayment has failed across a large area, a full replacement is the honest answer. Call (888) 255-8179 and we’ll tell you which you’re looking at.
How long does the swap or repair take? Most tile repairs and small replacements finish in a single visit. A full re-roof runs several days depending on square footage and pitch. We schedule and confirm timing before we start.
How do you source the right Unilock part? We confirm your tile profile on-site – by stamp, paperwork, or physical measurement – then match it to the correct Unilock or aftermarket profile before ordering. We don’t guess a profile over the phone, because a wrong match is a leak waiting to happen.
Written by the team at Groundwork Construction Co. of Downey, serving Downey and nearby areas.












