







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Artesia: What to Expect
Concrete driveways and concrete work in Artesia usually run $4,500 – $12,000 for a full new driveway pour, and most jobs are finished in 3 to 5 working days once we start, with a 5 to 7 day cure before you park on it. A replacement where the old slab comes out sits at $5,000 – $14,000. Call (888) 255-8179 and we’ll walk your property, check access and grade, and put an exact number in writing. No vague range, no surprises later.
How the work actually goes, stage by stage

Concrete is unforgiving of shortcuts. A slab that fails in two years almost always failed at the prep stage, not the pour. Here’s the real sequence we run on an Artesia job, and what you’re deciding at each point.
Day 1: Site walk and layout
Before anyone touches a shovel, we measure the actual driveable width, check where the property line sits, and confirm the slope away from the garage. On Artesia’s tight lots this is where problems surface: a 1950s tract driveway might be 8 feet wide with a fence post two inches off the edge. You decide the finished width and whether we’re matching an existing apron at the sidewalk.
Day 1 – 2: Demolition and haul-off
We break out the old slab with a jackhammer and skid-steer, load it, and haul it. A standard two-car driveway is roughly 12 to 16 cubic yards of debris and takes most of a day. This is the moment any buried surprises show up – old footings, a stray drain line, tree roots pushing up through the base. You decide on the spot whether to remove a tree or route around it.
Day 2 – 3: Grading, base, and formwork
We excavate to depth, compact the subgrade, and lay 4 inches of compacted Class II base. Forms go up, we set the fall for drainage, and any rebar or mesh gets tied in. For a driveway carrying vehicles we spec #3 rebar on a 24-inch grid, not wire mesh alone – it’s the difference between a slab that cracks into pieces and one that holds together. This is when you confirm the finish and any joints or borders.
Day 3 – 4: Inspection and pour
Where a permit applies, the city inspects the forms and base before we pour. The pour itself takes a few hours for a standard driveway, then we float, edge, and cut control joints while the concrete is still workable. You don’t need to be there, but it’s worth seeing.
Day 4 – 5 and after: Cure and seal
Concrete reaches roughly 70% strength in a week. We keep you off it for 5 to 7 days, longer in cool weather, and seal it at the 28-day mark when it’s fully cured. Sealing isn’t cosmetic – it’s what keeps winter rain from working into surface pores.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The concrete options you’ll pick between
Concrete isn’t one product. What you choose here drives both the price and how the driveway looks in ten years.
- Standard broom finish – the default. A textured surface, good grip when wet, the lowest cost within the range. Suits most Artesia homes and hides tire marks well. You won’t win design awards, but it lasts.
- Exposed aggregate – we wash the top layer of cement away to reveal the stone underneath. Better traction, warmer look, costs more because of the extra labor and timing. Popular where the driveway is visible from the street.
- Colored or integral color – pigment mixed into the concrete rather than painted on top, so it won’t chip off. Holds color under Southern California sun far better than a surface stain.
- Reinforcement choice – wire mesh is cheaper and works for light foot traffic; #3 rebar on a 24-inch grid is what we put under anything a car parks on. This is a real cost line, not an upsell.
- Thickness – 4 inches handles standard cars. If you park a truck, an RV, or anything heavy, we go to 5 or 6 inches with a heavier base. Worth the added cost once; brutal to fix later.
For decorative borders and accents, Quikrete and Oldcastle products give us reliable color and mix consistency. If your project grows into a full hardscape with a Driveway & Pavers scope, that opens up Techo-Bloc and Cambridge Pavers options for the borders and aprons.
What concrete driveways and concrete work cost in Artesia

A new concrete driveway in Artesia lands between $4,500 and $12,000, and a full replacement with demolition runs $5,000 to $14,000. Five things push a job toward the top of that range:
- Square footage and width. A single-car apron at 250 square feet sits near the low end. A 600-square-foot two-car drive with a turnaround climbs toward $12,000.
- Condition of the old slab. Thick, reinforced concrete from a later pour is slower to break out and costs more in labor and disposal than a thin original.
- Access. On Artesia’s narrow lots and alley-load drives, if the skid-steer and dump truck can’t get close, everything gets wheelbarrowed by hand. That’s added labor, plainly.
- Reinforcement and thickness. Upgrading from mesh to rebar and from 4 to 6 inches adds cost, but it’s the right call for heavy vehicles.
- Permit and inspection. Where the city requires a permit for new driveway work, that adds review time and fees on top of the build.
A written estimate lists demolition, haul-off, base depth, reinforcement spec, thickness, finish, sealing, and permit handling as separate line items. What it typically doesn’t include unless we flag it: tree removal, drainage corrections, and work to reconcile any unpermitted structure the driveway abuts.
See the difference
Before
After
Before
After
Before
AfterWhat Artesia homes specifically do to this job
Artesia is a small, dense city of mostly 1950s and 1960s single-story tract homes on small parcels, and that shapes concrete work here in ways you won’t hit in newer suburbs. Lots are tight, so clearance between the driveway edge, the fence line, and the neighbor’s property is measured in inches – every pour is a fitting exercise. The city’s permitting office is known for strict plan-check reviews, so when a driveway borders a structure or changes drainage, we come in with a plan drawn to match, not a sketch on a napkin. The bigger surprise comes on pre-construction walks: in Artesia’s older tracts, many garages were converted or enclosed decades ago without permits, and that “phantom” square footage affects where the driveway can legally sit and how drainage has to run. If your project grows into that enclosed garage, homeowners often pair this with a Garage Conversion ADU in Artesia, and we reconcile the unpermitted work before any concrete goes in. One more local note: the mild, dry weather here is easy on concrete, but the intense winter rain bursts we get occasionally overwhelm older drainage, so we grade the slab and add drainage corrections as part of the job, not as an afterthought.
Serving Artesia, CA – Our Local Coverage Area
We serve Artesia and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – concrete driveways and concrete work in Artesia

A typical concrete driveway in Artesia takes 3 to 5 working days from demo to finished pour, plus 5 to 7 days of cure before you park on it and 28 days before we seal it. Narrow-lot access can add a day if material has to be moved by hand. Call (888) 255-8179 for a timeline built around your property.
It depends on what the work touches – new driveway construction, changes to drainage, or a slab abutting a structure can trigger a permit, while a straight replacement in some cases does not. Because Artesia’s plan-check review is strict, we confirm the requirement with the city before we quote, so your estimate reflects the real scope. Call us and we’ll sort out what applies to your address.
Yes in most cases. We form and pour up to the existing structure and keep it intact, working around footings rather than into them. If the garage was converted or enclosed without a permit in an older tract, the drainage and grade have to be handled carefully around it – and if your plans extend to a separate structure, homeowners often pair this with a New Detached ADU in Artesia and we sequence both. Call (888) 255-8179 to walk your site.
New concrete driveways here run $4,500 – $12,000, and a full replacement with demolition runs $5,000 – $14,000. The finish, thickness, reinforcement, and access are the biggest movers. Call (888) 255-8179 for an exact written quote – estimates are free.
Every concrete job we do is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right, in writing. Our technicians have up to 12 years of experience, arrive background-checked and in uniform, and the price in your estimate is the price you pay. Call (888) 255-8179 to get started.
Get a free estimate for concrete driveways and concrete work in Artesia
Call (888) 255-8179 and a live person answers, day or night. We’ll ask about your property, your access, and what you want the driveway to do, then schedule a free on-site estimate. You’ll get a written, line-item quote with the finish, thickness, and reinforcement spelled out, handled under our 730-Day Done Right Promise. We’re also glad to cover the wider scope if you’re planning a full Driveway & Pavers in Artesia project – just say so when you call, and we’ll bring the right plan to your Artesia property.
Written by the team at Groundwork Construction Co.












