







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Cerritos, CA: What the Job Costs and How It Runs
Replacing a bathroom vanity, re-tiling a floor or shower surround, and swapping fixtures in a Cerritos home usually runs $9,000 – $28,000 for a full three-fixture bathroom, or $800 – $3,000 for a vanity alone, and most of these jobs are finished in one to two weeks once materials are on site. The scope covers tear-out, subfloor and wall prep, tile setting, vanity and countertop installation, and connecting the sink, faucet, toilet and shower trim. Call (888) 255-8179 and we’ll walk your Cerritos bathroom and put real numbers on paper.
How a Vanities, Tile & Fixtures Job Moves, Stage by Stage

This isn’t a mystery box. Here’s the actual sequence we run on a Cerritos bathroom update, and what you’ll be asked to decide at each point.
Stage 1: Walkthrough and material selections (days 1 – 5 before work starts)
We measure the room, check the shutoffs and the condition of the existing drain and supply lines, and photograph the subfloor so there are no surprises later. You’ll pick your vanity size and door style, tile for floor and walls, and your fixture finish. That’s the decision window: once tile is ordered, the schedule locks to the lead time. Most tile in the $4 – $9 per square foot range arrives in 3 – 7 days; special-order vanities can take 3 – 5 weeks.
Stage 2: Demo and rough-in prep (day 1 – 2)
We pull the old vanity, toilet, and tile, haul it out, and inspect what’s underneath. In Cerritos homes from the 1960s through the 1980s, that’s where you find the real story: a rotted subfloor under the toilet flange, backer board nailed rather than screwed, or a shutoff valve that’s seized. If plumbing has to move for a wider vanity, this is the day it happens.
Stage 3: Substrate and waterproofing (day 2 – 3)
Tile fails from the bottom up, so we set cement backer board or a bonded waterproofing membrane over the wet areas and tape and mud the seams. Floors get a leveling pass if the joists have settled. This stage is unglamorous and it’s the one that decides whether your tile is still tight in ten years.
Stage 4: Tile setting and grout (day 3 – 7)
Floor tile goes down first, then wall tile and the shower surround. Large-format tile takes longer to set than a 12×12; a herringbone pattern adds a day or more of labor. Grout and caulk come after a full cure. You’ll want to be available to confirm grout color, because that’s a decision people regret rushing.
Stage 5: Vanity, countertop, and fixtures (day 7 – 10)
Vanity sets, countertop drops in, sink and faucet connect, toilet resets, and shower trim, mirror, and lighting go in. We test every connection under pressure, run the water, and walk the room with you. Final inspection, if the job required a permit, gets scheduled from here.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
Most of the cost swing in a Cerritos vanity, tile and fixtures job comes from three decisions: what the vanity is made of, what the tile is, and what the fixtures are. Here’s the honest trade-off on each.
- Vanity construction – particleboard with laminate vs. plywood with a painted or stained finish vs. solid wood. Laminate over particleboard is the budget option and it does fine in a dry bathroom, but it swells if the sink ever leaks. Plywood boxes with a factory finish, like the KraftMaid lines we install, cost more up front and hold up for decades. Solid wood is the premium choice and mostly a style call.
- Countertop – cultured marble vs. quartz vs. granite. Cultured marble is the cheapest and needs periodic resealing. Quartz, including Cambria, is non-porous, needs no sealing, and resists the hard water spots we see across the LA Basin. Granite is beautiful and porous; it wants sealing every year or two.
- Floor tile – porcelain vs. ceramic vs. natural stone. Porcelain is denser, absorbs almost no water, and is the right call for a bathroom floor. Ceramic is softer and cheaper but chips more readily. Natural stone looks best and demands the most sealing and care.
- Shower wall tile – large-format porcelain vs. mosaics vs. slab. Larger tile means fewer grout lines to scrub. Mosaics mean more grout and more maintenance, but they grip underfoot. Slab is the cleanest look and the priciest.
- Fixtures – finish and brand. Chrome is the least expensive and the easiest to keep clean. Brushed nickel and matte black cost a bit more. Kohler and similar brands cost more than builder-grade and the difference shows in the valve cartridges, which are what fail first.
What Vanities, Tile & Fixtures Costs in Cerritos, CA

For Cerritos, expect $9,000 – $28,000 for a full bathroom of vanities, tile and fixtures, and $800 – $3,000 for a vanity installation on its own. A walk-in shower with new tile and trim sits roughly in the $4,500 – $12,000 band. Here’s what pushes a job toward the low or high end.
- Room size and tile square footage. A 5×8 hall bath is the low end. A primary bath with a large shower and a double vanity lands high.
- Existing condition. Original 1970s plumbing and a rotted subfloor add real labor. A bathroom that was updated within the last 15 years usually doesn’t.
- Moving plumbing, electrical, or walls. Relocating a drain for a bigger vanity or shifting a wall for a linen niche means rough-in work and often a permit.
- Material grade. Porcelain and a stock vanity vs. natural stone and a custom vanity can swing the number by $5,000 or more on the same footprint.
- Permit scope. Tile and fixture swaps often don’t require one. Moving plumbing or electrical does, and that adds inspection time and cost.
A written estimate from us breaks the job into line items: demo, substrate, tile labor by square foot, vanity and countertop, fixtures, and permit fees if any. What it won’t include is anything we haven’t confirmed on site, and we don’t issue change orders for work we should have caught at the walkthrough. The number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Cerritos Homes Specifically Do to This Job
Cerritos is a fully built-out, master-planned city. Nearly every lot was developed between the late 1960s and the 1990s under planned-unit-development standards, so essentially all our work here is remodel on aging tract homes, not new construction. In the 1960s and early 1970s builds around the 90703 ZIP, we regularly find original galvanized supply lines and, in some cases, aluminum branch wiring, which means a vanity swap can turn into a partial re-pipe or a panel question before the tile ever goes down.
The city’s design-review process matters here too. Because Cerritos enforces PUD architectural standards, exterior changes usually need approval, and while an interior bathroom tile and vanity job generally doesn’t trigger design review, anything that touches the exterior envelope, venting, or window does. That’s the piece contractors from Norwalk or Bellflower routinely miss. If your project grows into a wider scope, our Bathroom Remodeling in Cerritos page covers the full picture, and our Bathroom Remodeling service page lays out every option under that umbrella.
Water is the other local factor. The region’s hard water leaves mineral scale on fixtures and grout, so we spec non-porous surfaces and epoxy grout where it makes sense. If your bathroom refresh happens alongside a bigger exterior project, homeowners often pair this with Tile Roofing in Cerritos or Specialty Roofing in Cerritos, since both are on the same age clock as the house. We cover the whole of Cerritos, from the tracts near the 605/91 interchange to the condo clusters by the Town Center.
Serving Cerritos, CA – Our Local Coverage Area
We serve Cerritos and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Vanities, Tile & Fixtures in Cerritos

Most Cerritos bathrooms are finished in 7 – 14 working days once tile and the vanity are on site. The variable is material lead time, not labor. Special-order vanities can add 3 – 5 weeks to the start date. Call (888) 255-8179 and we’ll map the schedule against your selections.
Usually not, if you’re replacing fixtures and tile in the same locations. A permit is typically required when plumbing or electrical moves, or when a wall changes. Because Cerritos runs a strict permit and design-review process, we check the scope against current city requirements before we start and pull what’s needed. Call (888) 255-8179 to talk through your specific plan.
Yes, and that’s the most common job we do. A same-size vanity swap and a tile replacement over the existing footprint keeps the plumbing and drain where they are and avoids a permit. Two things force a move: going to a wider vanity than the rough-in allows, or a drain that’s already failing.
A vanity installation alone runs $800 – $3,000, and a full bathroom of vanities, tile and fixtures runs $9,000 – $28,000. The high end comes from larger rooms, stone tile, custom vanities, and any plumbing relocation. Call (888) 255-8179 for an exact quote – estimates are free.
Every project we do is covered by the 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it covers the tile setting and fixture installation, not just the materials. Our technicians have up to 12 years of experience, and we stand behind the work in writing.
Get a Free Estimate for Vanities, Tile & Fixtures in Cerritos
If you’re ready to price a vanity, tile or fixture job in Cerritos, call (888) 255-8179. A live person answers, day or night. We’ll set up a free on-site estimate, measure the room, review your material options, and hand you a written line-item quote with no surprises. Projects over $10,000 get $1,000 off, and 0% financing for 18 months is available.
Written by the team at Groundwork Construction Co.












