







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Bellflower, CA: What It Costs and How Long It Takes
Concrete driveway installation in Bellflower runs $4,500 to $12,000 for a typical single-car or short double drive, and a full replacement with demo and haul-off lands $5,000 to $14,000. Most residential driveways here are poured, cured and ready to park on in 5 to 7 days, with a 7-day cure before you drive on it and around 28 days before it reaches full strength. Call (888) 255-8179 for a free on-site estimate with a written line-item quote.
From Demo Day to the First Car: How Our Concrete Work Moves

Concrete looks simple from the sidewalk. It isn’t. Here’s the actual sequence we run on a Bellflower driveway, so you know what each day is for and what you’ll be asked to decide.
Stage 1: Demo and haul-off (1 to 2 days)
We break out the old slab, load the rubble and haul it. On Bellflower’s older blocks, this is the stage where we find out what’s underneath – old root systems, buried sprinkler lines, sometimes a second layer of concrete poured over the first by a previous owner. If we hit the double-pour, we stop and show you before we add a dollar. The number on your quote holds unless you approve a change in writing.
Stage 2: Excavation and base prep (1 to 2 days)
We dig to the right depth, then grade and compact the subgrade. This is where driveways that fail early get it wrong: a 4-inch pour over soft ground will crack no matter how good the mud is. We compact in lifts and check grade with a level and string line. Your decision here: drainage. Bellflower’s flat, tight lots often want the surface pitched toward the street or toward a swale, and you’ll pick the direction with us before the base goes down.
Stage 3: Forming, rebar and inspection (1 to 2 days)
We set forms, lay a rebar grid or wire mesh, and place expansion joints against the garage slab and any hardscape. If you’re widening the apron, cutting the curb or extending into the parkway, that’s the piece that needs a permit and a city inspection, and we schedule it before the pour. Concrete work that touches the right-of-way is the item people most often skip, and it’s the one that causes trouble later.
Stage 4: The pour (1 day)
Short day, long hours. We pour, screed, float and finish. You’ll have already chosen the finish by now, so this day is about execution, not decisions. Broom finish for a standard drive, light salt finish for grip on a slope. We also talk through where control joints go so the cracks land where they’re supposed to.
Stage 5: Cure, cure, cure (7 to 28 days)
We keep the slab damp and covered for the first several days, which matters more in Bellflower’s hot, dry summers than most people realize. Concrete that dries too fast loses strength and shrinks into cracking. You can walk on it in 24 to 48 hours, drive on it after about 7 days, and it hits full compressive strength around 28 days. Your only job here is patience.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make on a Bellflower Concrete Job
Concrete isn’t one product. Here’s what we typically walk homeowners through, with the honest trade-off on each:
- Standard broom-finish concrete, 4-inch slab: The workhorse for a residential drive, $4,500 to $12,000 depending on size and prep. Grippy, no-frills, holds up for decades if the base is right. Best value for most Bellflower homes.
- Thicker slab (5 to 6 inches) with a heavier rebar grid: Pushes the top of the range. Worth it if you park a truck, an RV or a heavy trailer. Overkill for a sedan.
- Exposed aggregate: Runs higher than broom finish, gives texture and a little color variance, and hides tire marks and dust better. A good middle choice on a hot, dusty block.
- Standard gray vs. integral color: Integral color adds cost and can mottle if the crew pours in stages. Pick a single-pour job if color consistency matters to you.
- Control joints and expansion joints: Not optional on a Bellflower driveway of any real size. They tell the concrete where to crack instead of letting it pick.
- Drainage additions (channel drain, apron cut, swale): Adds to the number but fixes ponding at the garage door before it finds its way inside. On flat inland-LA lots this is often the smartest money on the job.
Where finishes overlap with a wider hardscape scope, that’s part of a full Driveway & Pavers in Bellflower plan, and we’ll map the whole yard at estimate time so nothing gets poured twice.
What Concrete Driveways & Concrete Work Costs in Bellflower, CA

Most residential concrete work in Bellflower lands between $4,500 and $14,000. Here’s where the money goes and what moves you up or down.
| Line item | Typical range |
|---|---|
| Concrete driveway installation (new) | $4,500 – $12,000 |
| Driveway replacement (demo + new pour) | $5,000 – $14,000 |
| Small concrete pads, aprons, walkway strips | Lower end of the install range |
| Driveway sealing (after cure) | $250 – $700 |
The four things that push a job up or down:
- Square footage and thickness. A single-car drive and a full double with a turn apron are two different budgets. Thickness from 4 to 6 inches is a real dollar jump.
- Existing condition. A clean single-pour demo is quick. Double-pours, thick old slabs, or root systems under the base add days and hauling cost.
- Drainage and grading. If we have to cut, re-grade or add a channel drain to stop ponding at the garage, that’s real work.
- Permit scope. Anything touching the curb, apron or public right-of-way brings the city in. Interior pads and back-of-lot pours usually don’t.
- Finish and color. Broom is the baseline. Exposed aggregate and integral color sit above it.
Your written estimate spells out demo, haul-off, base prep, rebar, form work, the pour, finishing and cleanup. What it typically does not include unless you ask: landscape repair beyond the work zone, drainage fixtures, and any permit fees, which we list line by line rather than burying.
See the difference
Before
After
Before
After
Before
AfterWhy Bellflower’s Older Blocks Change the Concrete Estimate
Bellflower is a built-out mid-century suburb, and that shows up in the dirt. Most of the work here is remodel, repair and replacement on 1940s – 1960s tract homes with detached garages on small lots, not new ground-up builds. That means when we tear out a driveway off a block near Clark Avenue or along the older streets by the 90706 ZIP, we’re often pulling up a slab that’s been patched a few times by previous owners. Underneath, it’s not unusual to find old sprinkler lines, remnants of a former walkway, or a previous pour that was never properly trenched or compacted.
Hot, dry inland-LA summers and mild rainy winters do the rest. Sun bakes the surface, occasional wet winters push water into any hairline crack, and over a few seasons that crack becomes a heave at the garage door. Detached garages are common here, which means the drive usually runs from the street to a structure that’s settling at its own pace. If you’re also considering converting that detached garage, there’s a real overlap with a Garage Conversion ADU in Bellflower, and it pays to plan the driveway and the conversion together so you don’t pour over a line you’ll need to move a year later. The same applies to a backyard pour when the plan is a New Detached ADU in Bellflower – the slab, the trenching and the utility locations all want to be decided in one pass. Our crews cover concrete work across Bellflower, and we’ll flag the overlaps on the estimate.
Serving Bellflower, CA – Our Local Coverage Area
We serve Bellflower and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Concrete Driveways & Concrete Work in Bellflower

Plan on 5 to 7 working days from demo to finish, then 7 days before you drive on it and about 28 days for full strength. Small pads and patches can be a single day plus cure. Call (888) 255-8179 to get a firm timeline for your drive – the estimate is free.
It depends on the scope. A driveway extending into the parkway or apron, a curb cut, or anything touching the public right-of-way typically needs a permit and inspection; interior pads and private-yard pours usually don’t. We tell you up front which it is, list permit fees on the quote, and handle the paperwork. Call (888) 255-8179 to walk through your project.
An overlay is sometimes possible, but not usually advisable on a Bellflower drive. If the old slab is cracked, heaving or sitting on soft base, a thin overlay just fails along the same lines. For most of the 1940s – 1960s drives here, a clean replacement is the better long-term spend. We’ll tell you honestly at the estimate if overlay is the right call.
Concrete driveway installation runs $4,500 to $12,000, and a full replacement is $5,000 to $14,000. Size, slab thickness, demo condition, drainage and finish are what move the number. Call (888) 255-8179 for an exact quote – estimates are free and the price is upfront, no surprises.
Yes. Every concrete driveway and concrete job we complete is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. The number you see on the written quote is the number you pay. Call (888) 255-8179 to schedule your estimate.
Get a Free On-Site Concrete Estimate in Bellflower
Call (888) 255-8179 and a live person picks up, day or night. We’ll set a time to walk your drive, measure the pour, check the base, and hand you a written line-item estimate with permits called out separately. You’ll see the whole number before you commit, and 0% financing for 18 months is available if you’d rather spread the cost. Start with our Driveway & Pavers service if you want the wider hardscape picture first.
Written by the team at Groundwork Construction Co.












