







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Patios, Walkways & Pool Decks in Pico Rivera: What the Job Really Takes
Most patios, walkways and pool decks in Pico Rivera run $3,500 to $11,000 for a paver patio, with walkways and pool surrounds priced separately by square footage, and a typical job finishes in 3 to 7 working days once materials land. You’re usually resurfacing or replacing a slab that’s been baking in inland summer heat since the 1950s or 60s, so prep and drainage matter as much as the finish. Call (888) 255-8179 for a free on-site estimate.
How we build Patios, Walkways & Pool Decks, stage by stage

Outdoor flatwork isn’t a mystery once you’ve watched it go in a few hundred times. Here’s the actual sequence on a Pico Rivera job, with the decisions that land on you at each step.
Stage 1: Walk-through and layout (day 1, roughly 1 to 2 hours)
We measure the yard, check where the hose bibs, irrigation lines and downspouts sit, and confirm the slope away from the house. You decide the patio footprint, the walkway width (36 inches is the practical minimum for two people passing), and whether the pool deck ties into the existing coping or gets its own edge. This is also where we flag anything underground that changes the plan.
Stage 2: Demolition and base prep (days 1 to 2)
Old cracked concrete comes out and goes to the dumpster. We excavate 4 to 6 inches, compact the subgrade, then build a crushed aggregate base in lifts. Skipping compaction is the number one reason a new patio settles unevenly two winters later. For Pico Rivera’s older lots, we also check for the shallow root systems from mature ficus and citrus that heave slabs.
Stage 3: Drainage and utility rough-in (day 2)
We set the pitch, install any needed drainage, and sleeve conduit for future lighting or a gas stub for a barbecue. If the walkway has to cross an irrigation main, we move it now, not after the pavers are down. You confirm whether you want low-voltage path lighting included at this point, since it’s cheap to add during prep and expensive to add later.
Stage 4: Setting the surface (days 3 to 5)
Pavers go down on a screeded sand bed, cut tight at the house and pool edge, then compacted and swept with polymeric joint sand. Concrete gets formed, poured and finished. A pool deck needs a slip-resistant finish and a slight fall away from the water; we don’t cut corners on that because standing water on a pool surround is a real slip hazard.
Stage 5: Cleanup and final walk (day 5 to 7)
We clean the joints, wash down the surface, haul off the debris and walk the finished job with you. Anything that fails the walk gets fixed before we call it done, and the work is covered by our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between for a Pico Rivera patio or pool deck
Material choice drives both the price and how the surface feels in August. Here’s the honest trade-off on each.
- Concrete pavers (Techo-Bloc, Cambridge or Oldcastle): The most common pick for patios and pool decks here. Individual units can be lifted and reset if one cracks or settles, which matters on older lots with shifting soil. Runs $3,500 to $11,000 for a patio; higher-end textured lines push the top of that range.
- Poured concrete with a broom or exposed-aggregate finish: The budget option and the fastest to install. It’s one continuous slab, so it cracks where it wants to. Good for a simple walkway, less forgiving around a pool.
- Stamped concrete: Gives you a stone or slate look on a poured slab for less than real pavers. The trade-off is that the color is a surface treatment and can fade or chip over time.
- Travertine or natural stone pool decks: Cooler underfoot than concrete in the Pico Rivera heat, which is why pool owners ask for it. Costs more and needs sealing every couple of years.
- Walkway width and border: A plain 3-foot path is the value play. Widening to 4 feet or adding a contrasting soldier-course border (using Quikrete polymeric sand in the joints) tightens the look and adds cost.
What Patios, Walkways & Pool Decks costs in Pico Rivera, CA

A paver patio in Pico Rivera typically lands between $3,500 and $11,000. Here’s how the pieces break out so you can see where your money goes.
| Item | Typical range |
|---|---|
| Paver patio installation | $3,500 – $11,000 |
| Walkway (per linear foot, installed) | priced by square footage within the patio range |
| Pool deck resurfacing or new surround | quoted with patio work, priced by area |
Four things push a job toward the high end. Size is the biggest: a small 120-square-foot patio sits near the bottom, a 400-square-foot patio with a pool surround climbs toward the top. Existing condition matters, because tearing out sound concrete is cheaper than jackhammering a heaved, root-damaged slab. Drainage and grading add cost if the yard currently pools water against the house. And your material grade (a premium Techo-Bloc line versus a standard Cambridge unit) moves the number by a few thousand on its own.
A written estimate from us is line-itemed: demolition, base, materials, joint sand, labor and cleanup each show a number, and that number doesn’t change once work starts. What’s typically not included in a base quote: relocating irrigation or gas lines, structural work, and haul-away of anything beyond the demo debris. Call (888) 255-8179 for an exact quote – estimates are free, and there’s $1,000 off projects over $10,000 plus 0% financing for 18 months if you’re bundling this with bigger work.
See the difference
Before
After
Before
After
Before
AfterWhat Pico Rivera homes specifically do to this job
Pico Rivera is a built-out, post-war suburb, and nearly every single-family house on these gridded streets went up in the 1950s or 60s. That shapes the work in ways a newer city wouldn’t. We’re almost always tearing out an original slab or patching around a detached garage that was converted decades ago, not starting from bare dirt. The hot inland summers and dry Santa Ana winds crack and fade old concrete fast, and winter rains expose any drainage that was never set right. On the older LA County lots here, a patio that ties into a room addition or a ADU Site Prep & Utilities in Pico Rivera project often needs a permit because it’s part of a larger structural scope, so we pull it and pass inspection rather than leaving you with an unpermitted surface. If the patio is the outdoor half of a bigger update, homeowners often pair it with Full Kitchen Remodeling in Pico Rivera so the whole house gets done in one coordinated push. We cover the full Pico Rivera area across ZIP codes 90660, 90661 and 90662. When the project grows to include the front, that’s part of a full Driveway & Pavers in Pico Rivera scope, and you can see our wider Driveway & Pavers service for the full picture.
Serving Pico Rivera, CA – Our Local Coverage Area
We serve Pico Rivera and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Patios, Walkways & Pool Decks in Pico Rivera

A typical patio or pool deck takes 3 to 7 working days from demo to final walk, assuming materials are on site. Larger jobs with extensive grading or a big pool surround can stretch to about two weeks. Call (888) 255-8179 and we’ll give you a realistic start date, not a vague “sometime.”
A standalone ground-level patio usually doesn’t need a permit, but a pool deck tied to a pool, or a patio attached to a room addition or garage conversion, often does under older LA County rules. We tell you up front which applies and pull what’s required. Call (888) 255-8179 to sort out the permit question on your specific lot.
Usually yes. We design the layout around existing hose bibs and irrigation where the slope allows, so you’re not paying to relocate lines you don’t have to. If a line sits exactly where the walkway needs to go, we move it during prep and tell you the cost before we start. Call (888) 255-8179 for a free estimate.
Pool deck work is priced by square footage within our patio range, with the need for a slip-resistant finish and proper fall away from the water being the main cost factors. A travertine deck runs higher than concrete pavers or a poured surround. Call (888) 255-8179 for an exact quote – estimates are free.
Every patio, walkway and pool deck we build is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in the residential construction space, and it’s backed in writing. Call (888) 255-8179 with any warranty question.
Get a free estimate for Patios, Walkways & Pool Decks in Pico Rivera
When you’re ready to price the project, call (888) 255-8179 or request a free on-site estimate. We walk the yard with you, measure, talk through materials, and hand you a written line-item quote with upfront pricing and no surprises. Our technicians are background-checked and arrive in uniform, and a live person answers the phone whenever you call. Let’s get your Pico Rivera outdoor space built right.
Written by the team at Groundwork Construction Co.












