







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Montebello, CA: What It Costs and How Long It Takes
A tub-to-shower conversion in Montebello typically runs $3,500 to $10,000 and takes about 7 to 14 working days from demo to final inspection, depending on whether we’re moving the drain and how far the wall behind the old tub has deteriorated. The job means pulling the tub, reworking the drain and valve rough-in, waterproofing the wet zone, and setting a new shower pan and walls in the same footprint. Call (888) 255-8179 for a free on-site estimate with a written, line-item number before anything gets torn out.
How a Tub-to-Shower Conversion Actually Runs, Stage by Stage

This isn’t a swap. A tub drain sits at one end of the alcove; a shower pan drain sits centered, so the plumbing rarely stays put without some rework. Here’s the real sequence we follow on Montebello jobs.
Stage 1: Teardown and what’s hiding behind the wall (Day 1 – 2)
We protect the floor and hall, shut the water, and pull the tub, surround, and valve trim. This is the day we learn what the last remodel left. In Montebello’s older bungalows we routinely find original galvanized supply lines, cast-iron drain stubs, and greenboard where cement board belongs. You decide right here whether to replace the valve while the wall is open, which is far cheaper now than later.
Stage 2: Rough-in and inspection (Day 2 – 4)
We relocate the drain toward center and set a new drain assembly, then pressure-test the lines. If the valve is being replaced, this is when it goes in. Our plumber calls for rough plumbing inspection and we don’t close the wall until it passes. You choose the trim style here: Moen and Delta both make valve-and-trim kits at several price points, and this is the moment to lock that in.
Stage 3: Waterproofing (Day 4 – 6)
Cement board or a bonded waterproof membrane goes over the studs, seams get taped and sealed, and the pan gets a pre-slope and liner or a molded pan with a liquid-applied membrane over it. This stage is invisible when it’s done and it’s the one that decides whether the job lasts. We flood-test the pan and hold it before tile starts.
Stage 4: Tile and finish (Day 6 – 11)
Wall tile, floor tile or a pan finish, niche, curb, and grout. You pick tile size, layout, and grout color before this stage begins, not during it. Larger format tile means fewer grout lines to scrub; smaller tile lets the floor slope to the drain better. Kohler fixtures slot in cleanly here if you’re upgrading the showerhead and controls.
Stage 5: Glass, trim, final inspection (Day 11 – 14)
Glass panel or door goes on, silicone cures, trim and accessories go up, and we walk the city inspection. You get a final walkthrough and the written warranty. Most of our Montebello conversions land in this window; a full gut with structural repairs pushes toward the 14-day end.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Be Making, and What Each One Costs You
The dollar swing in a tub-to-shower conversion comes from a handful of decisions you make before demo. Here’s what each one actually means.
- Acrylic or fiberglass pan and surround: the fastest and least expensive route, usually toward the low end of the $3,500 – $10,000 range. Fewer grout lines, easy to clean, holds up well in a rental or secondary bath. Not the option for someone who wants a custom look.
- Tile walls with a tiled or molded pan: the mid-to-upper part of the range. Tile lets you match the rest of the bathroom and gives you layout control. It requires real waterproofing underneath and periodic grout care over the years.
- Tub-to-shower with a built-in seat or bench: adds framing and tile. Suits an aging-in-place household or anyone who wants a place to sit. Adds cost and takes a day.
- Glass type: framed sliding doors cost less and hide a slightly out-of-square opening; frameless glass looks cleaner but demands a square, plumb opening, which old Montebello walls rarely are without correction.
- Valve and trim: keeping the existing valve saves money; replacing it means opening the wall, but it’s the right call if the valve is old or the water pressure is uneven. Delta and Moen kits span a wide range here.
- Niche and storage: a recessed shampoo niche costs little at framing stage and a lot to add later. Decide before the board goes up.
What Tub-to-Shower Conversion Costs in Montebello, CA

Plan on $3,500 to $10,000 for a tub-to-shower conversion in Montebello, with most jobs landing in the $5,000 – $8,000 band once you account for drain relocation and a valve replacement.
| Line item | Typical range |
|---|---|
| Basic acrylic pan and surround, existing drain | $3,500 – $5,500 |
| Tile walls and tiled pan, drain relocation | $5,500 – $8,000 |
| Custom tile with seat, niche, frameless glass | $8,000 – $10,000 |
| Valve and trim replacement (add) | $400 – $900 |
| Subfloor or framing repair if rot is found (add) | $500 – $1,800 |
What pushes a job to the low end: a straight swap in the same footprint, no drain move, acrylic walls, existing valve in good shape. What pushes it high: relocating the drain, replacing old galvanized or cast-iron lines, opening a load-bearing wall, correcting framing that’s out of plumb, and going with custom tile and frameless glass.
A written estimate from us includes demo, haul-away, rough plumbing, waterproofing, tile or surround, setting materials, finish trim, glass, and the permit. It doesn’t include structural repairs found after demo, upgraded fixtures beyond the allowance, or tile overage from a complicated layout. We flag any of those before we proceed, not after.
See the difference
Before
After
Before
After
Before
AfterWhat Montebello Homes Specifically Do to This Job
Montebello is built out. There’s almost no new construction here; the work is remodel and retrofit on the 1920s – 1950s bungalows and small stucco tract homes packed onto narrow postwar lots, mostly in 90640. That housing stock changes this job in ways it wouldn’t in a newer city. When we open a wall behind an old tub on a Whittier Boulevard block or up in the hillside streets off Montebello Boulevard, we plan for original plumbing, early wiring, and framing that’s had 70 years to settle out of square. Lead and cast-iron drain lines are common, and greenboard or drywall behind old tile has usually absorbed enough moisture that it comes out in pieces, which adds a day.
Because lots are tight and the rear alley access is often shared, dumpsters and material delivery have to be scheduled around neighbors’ driveways and the alley itself. Down in the hillside areas near the Montebello Golf Course, sloped sites can mean more shoring and a slower demo. And on the hotter inland side of the LA Basin, attics and walls get hot enough in summer that we schedule demo early in the day.
Permits matter here. Montebello’s building review is thorough, and a tub-to-shower conversion that relocates the drain or replaces the valve is treated as a plumbing and structural alteration, not a cosmetic update, so it requires a permit and inspection. We pull it and pass it. If your conversion is part of a larger scope, this often sits inside a full Bathroom Remodeling in Montebello, and we coordinate the trades as one job. For a wider project outside the tub alcove, see our Bathroom Remodeling service. We cover all of Montebello and the surrounding areas, and homeowners often pair exterior weatherproofing with this work, adding Metal Roofing in Montebello or Tile Roofing in Montebello in the same season.
Serving Montebello, CA – Our Local Coverage Area
We serve Montebello and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Tub-to-Shower Conversion in Montebello

Most conversions take 7 to 14 working days from demo to final inspection. Simple acrylic jobs finish closer to a week; tile with drain relocation and a valve replacement pushes toward two weeks. Call (888) 255-8179 for an exact timeline based on your bathroom.
Yes, if the drain or valve is being relocated or replaced. Montebello treats that as a plumbing alteration requiring a permit and inspection. We pull the permit and handle the inspection as part of the job, and the cost is in your written estimate.
Sometimes, but it depends on the drain location. A tub drain sits at one end; a shower pan drain needs to be centered enough for proper slope. If the location works without moving the drain, the job stays at the low end of the $3,500 – $10,000 range. We confirm this at the free estimate before demo.
Between $3,500 and $10,000, with most jobs at $5,000 – $8,000. Material grade, drain relocation, valve replacement, and any rot found after demo are the main variables. Call (888) 255-8179 for a fixed, line-item quote before work starts – the number you see is the number you pay.
Every tub-to-shower conversion we do is covered by our 730-Day Done Right Promise. If the waterproofing, tile, or plumbing fails within that period, we come back and fix it. The warranty is written into your contract, not buried in fine print.
Get a Free Tub-to-Shower Conversion Estimate in Montebello
Tell us the bathroom size and whether the tub is cast iron or fiberglass, and we’ll schedule a free on-site estimate. We measure the alcove, check the valve and drain, and hand you a written line-item quote with a fixed price. Calls are answered by a live person around the clock, and your estimate is free. Call (888) 255-8179 to book yours.
Written by the team at Groundwork Construction Co.












