







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Lakewood, CA: What It Takes and What It Costs
Door installation in Lakewood typically runs $450 to $2,800 per door depending on type, and most single-door swaps are finished in one day. Entry and patio door replacements that touch framing or stucco stretch to two or three days. Lakewood’s 1950s tract homes almost always need some rough-opening work, because the original door frames have swelled and shifted over seven decades. Call (888) 255-8179 for a free on-site estimate with a written, line-item quote.
How We Handle a Door Installation, Stage by Stage

Every door job follows the same sequence. What changes is how much of Lakewood’s original framing we find once the old door comes out.
Stage 1: On-site measure and door selection (day of estimate)
We measure the rough opening, check the frame for plumb and square, and confirm the wall assembly behind the trim. You pick the door type and material at this stage, because lead time depends on it. A stock steel entry door can be ready in days. A custom-sized slider or a fiberglass entry door with a specific glass package takes longer. The estimate is written and itemized before you commit to anything.
Stage 2: Order and pre-hang prep (varies by lead time)
We order the door, confirm the swing direction and handing, and schedule the install. Most of the waiting happens here, not on the job. If your door needs a permit (exterior doors on a structural opening usually do), we pull it during this window so there’s no idle time on install day.
Stage 3: Demo and rough opening inspection (2 – 4 hours)
We remove the old door, casing, and threshold. On Lakewood homes from the early 1950s, this is where we find out what we’re actually dealing with: rotted sill plates, out-of-square framing, or stucco that’s pulled loose around the opening. If the framing is sound, we move straight to prep. If it isn’t, we show you what we found before we do anything about it, with a written change order if the scope grows.
Stage 4: Installation and sealing (3 – 5 hours)
We set the new door, shim and plumb it, anchor the frame, and insulate the gap. Flashing and weather sealing go in before the trim, not after. This is the stage that decides whether a door leaks in five years. We use expanding foam sparingly and backer rod where the gap is wide, because over-foaming a frame is one of the most common causes of a door that won’t close right.
Stage 5: Trim, hardware, and final check (1 – 2 hours)
Casing, threshold, and finish hardware go on last. We test the swing, check the latch and deadbolt alignment, and confirm the door closes flush without dragging. We walk the finished opening with you before we leave, and every exterior door install is backed by our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Door Options You’ll Choose Between
The material and configuration you pick drives most of the price and all of the long-term maintenance. Here’s what actually matters in Lakewood’s climate:
- Steel entry doors: The most common choice for a front door. They hold paint well, resist denting, and insulate better than wood. The trade-off is that dents and rust at the bottom edge are hard to fix, and a cheap steel door feels hollow. Expect the low-to-mid end of the price range.
- Fiberglass entry doors: Better dent and moisture resistance than steel, and they can be finished to look like stained wood. They cost more upfront but need almost no maintenance, which suits Lakewood’s dry-then-damp cycle. A strong choice for a south- or west-facing door that takes sun all afternoon.
- Solid wood doors: The classic look, and the most expensive to maintain. In Lakewood, wood doors want re-sealing every couple of years because the marine layer and the Santa Ana dry spells work the material in both directions. Beautiful, but they need attention.
- Interior doors (hollow-core or solid-core): Hollow-core is the budget default and fine for closets. Solid-core cuts sound transfer noticeably and is worth the upgrade in bedrooms and bathrooms. These are usually the fastest install of any door type.
- Sliding and French patio doors: The biggest-ticket option because the opening and the wall assembly are more involved. Vinyl and aluminum frames hold up well here. The trade-off is that a wide patio door replacement often means trim and stucco repair around the opening.
- Glass and finish packages: Decorative glass, sidelights, and transoms add cost fast. Decide what you actually want to look at every morning, then price it. Brands like CGI and ES Windows build entry and patio door systems that hold up well in Southern California sun.
What Door Installation Costs in Lakewood, CA

Here’s the honest range for this market, by door type:
| Door Type | Typical Installed Range |
|---|---|
| Interior door (hollow-core) | $450 – $900 |
| Interior door (solid-core) | $700 – $1,300 |
| Standard entry door (steel or fiberglass) | $1,200 – $2,200 |
| Premium entry door with glass and sidelights | $2,200 – $2,800+ |
| Sliding or French patio door | $1,800 – $2,800+ |
Five variables push a job toward the high end:
- Door size and handing: A non-standard width or a custom handing means a custom order.
- Existing condition: Rotted framing, water damage, or a wall that’s out of square adds demo and repair time.
- Stucco and trim repair: Lakewood’s stucco exterior means a patio door replacement almost always needs patch work around the opening.
- Material grade: A builder-grade steel door and a fiberglass door with a glass package are two different budgets.
- Permit scope: Exterior structural openings usually require a permit; interior door swaps usually don’t.
Our estimates are written and itemized: labor, materials, permits, and disposal are listed separately. The number you see is the number you pay. No-hassle upfront pricing means no change orders unless you approve the scope change in writing. Call (888) 255-8179 for an exact quote.
See the difference
Before
After
Before
After
Before
AfterWhat Lakewood Homes Specifically Do to This Job
Lakewood was built almost entirely between 1950 and 1955 as one of America’s first planned communities. Every tract home is wood-frame stucco on a concrete slab, and most still carry the original 2×4 framing and single-pane openings. That’s the fact that shapes every door install here: you’re retrofitting a 70-year-old opening to modern code and energy standards without changing the uniform mid-century street face that gives Lakewood its identity. In the older tracts around Mayfair Park and along Clark Avenue, we routinely find out-of-square rough openings and settled thresholds, because the same slab and framing plan was used block after block. The marine layer keeps moisture cycling through the stucco on the south and west walls, and the Santa Ana wind events dry old wood framing out hard. Both work the door frame. On exterior doors, that shows up as sticking, drafty gaps, and latch misalignment long before the door itself is worn out. We serve all four Lakewood ZIP codes (90712, 90713, 90714, 90715), and we pull permits and pass inspections on every job that needs them. Door work often goes alongside a bigger scope, so it’s common to pair a patio door replacement with our Windows & Doors in Lakewood service, or with Chain Link Fence in Lakewood or Vinyl Fence in Lakewood when a backyard project is happening at the same time.
Serving Lakewood, CA – Our Local Coverage Area
We serve Lakewood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Lakewood

Most single-door installations are completed in one day, roughly four to eight hours from demo to final check. A patio door replacement that involves framing or stucco repair usually runs two to three days. The install itself is fast; the wait is almost always the door order lead time, which is why we order as early as possible. Call (888) 255-8179 to schedule your free estimate and confirm your lead time.
Exterior door replacements that change the size of the rough opening or alter a structural wall almost always require a permit. Swapping an interior door of the same size usually does not. We handle the permit determination for you at the estimate and pull whatever’s needed before install day. Call (888) 255-8179 and we’ll tell you upfront whether your project needs one.
Yes, in most cases. A same-size door swap doesn’t touch plumbing or structure. The exceptions are patio doors that require reframing or a wall that’s out of square enough to need correction. We assess that during the estimate so you know before work begins. Call (888) 255-8179 for a free on-site look.
Interior doors run $450 to $1,300 installed; exterior entry doors run $1,200 to $2,200; premium entry doors with glass and sidelights can reach $2,800 or more; patio doors run $1,800 to $2,800 and up. Call (888) 255-8179 for an exact quote – estimates are free and written.
Every door we install is covered by our 730-Day Done Right Promise if it isn’t done right, we make it right. That covers the workmanship on the install, not manufacturer defects, which carry their own door warranty. Call (888) 255-8179 and we’ll walk you through exactly what’s covered.
Get a Free Door Installation Estimate in Lakewood
We come out, measure the opening, check the framing, and hand you a written, itemized estimate the same visit. You’ll know the price before you commit to anything. Our technicians have up to 12 years of experience, and every door install backs our 730-Day Done Right Promise. Call (888) 255-8179 to schedule your free estimate; a live person answers around the clock.
Written by the team at Groundwork Construction Co.












