







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
What a Chain Link Fence in Lakewood, CA Costs and How Fast It Goes In
A chain link fence in Lakewood, CA typically runs $3,500 – $9,000 for a standard residential lot, and most jobs are set and stretched in one to three days once we’ve marked utilities and passed the plan check. That price covers posts, top rail, tension wire, gates, and a fresh stretch of galvanized mesh along your rear or side lot line. Call (888) 255-8179 for a free on-site estimate.
How a Chain Link Fence Goes In, Start to Finish

The order of operations matters more than most homeowners expect, because a chain link fence is only as good as what’s under the posts. Here’s how we run the job and where you make the calls.
Stage 1 – Marking and the call to dig alert
Before anything goes in the ground, we stake the line and have the utility underground service marked. Lakewood’s tract lots often have irrigation, gas, and old lateral lines running where a property line appears empty, so we don’t guess. At this stage you confirm the exact line: side yard, back line, or a full perimeter. If there’s a shared fence with a neighbor on the property boundary, that conversation happens now, not mid-install.
Stage 2 – Layout and permits
We set string lines to the correct height and setback, then pull the permit if Lakewood’s building department requires one for your fence height and location. Your decision here is height and whether any section steps down a slope. Getting this right before we dig saves a rebuild later. The plan review typically adds a few days to the timeline, and we handle the submittal.
Stage 3 – Post setting and concrete cure
Posts go into augered holes set in concrete, spaced to standard so the mesh tension stays even. On Lakewood’s slab-on-grade lots, we’re careful where holes land near the house and driveway edges so we don’t cut into anything structural. The concrete needs to cure before we hang rail and pull mesh, which is why a two-day install beats a same-day rush every time.
Stage 4 – Rails, tension wire, and mesh stretch
Once the posts are locked up, we hang top rail, run the bottom tension wire, and stretch the chain link fabric from end to end so it reads tight and flat along the whole run. This is the stage that makes or breaks how the fence looks and holds. A loose stretch sags in a season.
Stage 5 – Gates, walkthrough, and clean-up
We hang the walk and drive gates, check that every latch catches and swings clear, then walk the line with you. Your last decisions are gate placement and hardware finish. Haul-away and site clean-up are part of the job, and the whole thing is backed in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Shape Your Chain Link Fence
Chain link isn’t one product. The specs below are what actually move the look, the lifespan, and the price.
- Galvanized vs. vinyl-coated mesh: Standard galvanized is the value pick and handles sun well. Vinyl-coated (often green or black) costs more, cuts glare, and reads softer against landscaping – a good fit if you want the fence to disappear into the yard.
- Gauge of wire: Heavier-gauge fabric lasts longer and resists sag. It’s worth the upgrade on a boundary you’ll live with for twenty years.
- Post and rail schedule: Residential vs. heavier posts, and top rail diameter. We size these to the run length so nothing bows.
- Height: Standard residential height versus a taller run – taller fences often trigger a permit and cost more per foot.
- Gates: A single walk gate, a double drive gate, or both. Drive gates add hardware, bracing, and cost.
- Finish hardware: Standard latches vs. self-closing or keyed hardware.
If the fence is part of a bigger exterior refresh, homeowners often pair this with Concrete Driveways & Concrete Work in Lakewood so the gate approach and the slab get done in one pass – and see our Fence Installation service for the full range of options.
What a Chain Link Fence Costs in Lakewood, CA

Most chain link fence jobs in Lakewood land between $3,500 and $9,000. That spread comes down to a handful of variables:
- Linear feet and corners: A simple back-line run sits at the low end; a full perimeter with multiple corners pushes toward the top.
- Height and permit scope: A taller fence that needs plan review and inspection costs more than a standard-height side yard.
- Gate count and type: Double drive gates and keyed hardware add to the total.
- Material grade: Vinyl-coated and heavier-gauge fabric cost more up front and last longer.
- Site conditions: Rocky soil, root removal, or a slope that needs stepped panels add labor.
A written estimate spells out linear feet, gauge, post schedule, gate count, and whether the permit is included. It also notes what’s not in the number – often landscaping repair or concrete work at gate approaches – so there are no surprises once work starts. Upfront pricing, no change orders: the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhy Lakewood’s Tract Housing Shapes This Job
Lakewood is a prototypical post-WWII planned community, laid out in 1950 – 1955, with roughly 25,000 single-story tract homes on a shared slab-and-framing plan. That uniformity has a direct effect on fencing. Because the lots and setbacks repeat block to block, we see the same failure pattern again and again in neighborhoods like Mayfair and around the Lakewood Country Club: original wood or rusted chain link that pulled out at the posts where roots and old lateral lines run. The marine layer and Santa Ana dry spells work on metal too, so galvanized posts near a sprinkler line tend to rust first. We work across every ZIP in Lakewood – 90714, 90712, 90715, and 90711 – and handle permits and inspection as part of the job. When we’re measuring, you’re on the schedule through Lakewood alongside the neighboring areas we serve.
Serving Lakewood, CA – Our Local Coverage Area
We serve Lakewood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Lakewood

Most residential chain link fence jobs take one to three days of on-site work once the permit is in hand, plus a few days of plan review if your height requires it. Call (888) 255-8179 for a timeline built around your lot.
It depends on height and location, and Lakewood’s building department has rules on both. A taller fence or a front-yard run almost always needs a permit and inspection; a standard-height rear fence often doesn’t. We check the requirement for your specific run and pull the permit when needed – so ask when we measure.
Linear feet, height, gate count, and mesh grade drive the number, with site conditions as the wildcard. The bulk of any job sits between $3,500 and $9,000. Call (888) 255-8179 for an exact quote – estimates are free.
Workmanship on your chain link fence is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. Material warranties come from the manufacturer and depend on the gauge and finish you choose.
Not from our side. We set a price on the written estimate and stick to it – the number you see is the number you pay. If something unexpected turns up underground, we stop and talk with you before anything changes.
Get a Free Chain Link Fence Estimate in Lakewood
Tell us the lot line and the height you have in mind, and we’ll come measure, confirm permits, and hand you a written line-item price for your chain link fence. Call (888) 255-8179 to schedule your free estimate. A live person answers 24/7 – no voicemail, no waiting until Monday. Project over $10,000? You qualify for $1,000 off, plus 0% financing for 18 months.
Written by the team at Groundwork Construction Co.












