







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Driveway Repair & Replacement in Lakewood, CA: What It Takes and What It Costs
Driveway repair and replacement in Lakewood usually means replacing a 5-6 inch slab or patching and re-surfacing failing sections, and most full replacements run $5,000 – $14,000. Plan on 3 to 5 working days from demolition to the day you can park on it again. Call (888) 255-8179 and we’ll walk your driveway, measure it, and hand you a written line-item estimate before any work is scheduled.
How We Actually Run a Driveway Repair & Replacement Job

Every driveway is different, but the sequence on a Lakewood job looks the same from start to finish. Here’s what each stage involves and the decisions you’ll make along the way.
Stage 1 – Site walk and layout (day 1, 45 minutes). We measure the slab, check slopes for drainage, look at where the existing joints, cracks, and low spots are, and confirm where the driveway meets the apron and garage floor. You decide at this stage whether you’re patching or replacing, and we tell you honestly which one makes sense for your slab.
Stage 2 – Demolition and haul-off (day 1 – 2, one day). The old concrete or asphalt comes out with a jackhammer and skid-steer, and we load and haul it the same day. If your driveway has a root lift or a sinking corner, we inspect the subgrade while the old slab is off and tell you what caused it.
Stage 3 – Subgrade prep and base (day 2, half day). We grade the subgrade, compact it, and lay 4 inches of crushed base. This is the step most homeowners never see and the one that determines whether your driveway cracks in five years or twenty. You approve the base depth and any drainage corrections before we pour.
Stage 4 – Forms, rebar, and pour (day 3, one day). We set forms to the correct slope, tie rebar or mesh on chairs, and pour. Control joints and expansion joints go in at the right spacing. You decide on broom finish versus exposed aggregate at this stage, and whether you want a decorative border.
Stage 5 – Cure and final walk (day 4 – 5, then 48 hours cure). Concrete cures to walk-on in under 24 hours and car-ready in 48 to 72. We come back for a final inspection, pull the forms, clean the site, and hand you the care instructions and warranty in writing.
Most Lakewood driveway replacements wrap in 3 to 5 working days. Patches and partial replacements can finish in a day. We schedule the pour for a dry window because the Santa Ana winds dry concrete faster than you’d expect, and we don’t want it curing too quickly.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between on a Lakewood Driveway
Once you’re replacing or repairing, the decisions fall into a handful of categories. Here’s the honest version of each.
- Full replacement vs. patching: Patch if the problem is one isolated section, like a single broken panel or a corner that sank from a root. Replace if the slab has more than 3-4 significant cracks, ongoing settlement, or is 30+ years old with a crumbling surface. Patching a failing slab is throwing money at a problem you’ll face again in two years.
- Concrete (standard): The most common choice on Lakewood tract homes, running roughly $4,500 – $12,000 installed. Broom finish, 5-6 inch slab, rebar. Holds up well in our climate. Stays the color it is or fades to a lighter gray.
- Exposed aggregate or stamped concrete: Adds $1,500 – $4,000 to the standard concrete price. More visual interest, slightly more slip-prone in wet weather, and needs resealing every few years.
- Asphalt: Cheaper up front at roughly $3,500 – $9,000, but it needs sealing every 2-3 years and lasts 15-20 years compared with 30+ for concrete. Fine for a rental or a tighter budget.
- Pavers: The high-end option in the $7,000 – $18,000 range, with individual units you can replace instead of the whole slab. Pricier and more labor, but the surface is repairable without a jackhammer. We install Belgard and similar quality paver lines.
- Width and length: A standard single-car driveway is 10-12 feet wide and 20-24 feet long. A double-car is 18-24 feet wide. Widening by a couple of feet to fit a truck or RV adds a few hundred to a couple of thousand to the job, depending on the base work required.
If you’re replacing the driveway as part of a wider exterior project, it’s worth looking at what else is on the table. That’s where our driveway & pavers service and the full Driveway & Pavers in Lakewood page come in: they cover patio, walkway, and paver work this page doesn’t.
What Driveway Repair & Replacement Costs in Lakewood, CA

A full driveway replacement in Lakewood runs $5,000 – $14,000. A concrete driveway installation runs $4,500 – $12,000, asphalt paving runs $3,500 – $9,000, and paver driveways run $7,000 – $18,000. Sealing the finished surface, if you want it, runs $250 – $700.
Here’s what actually pushes a job from the low end of that range to the high end:
- Size: A single-car driveway at 240 square feet is half the job of a 480-square-foot double. Every extra foot of width or length carries concrete, rebar, and base material with it.
- Existing slab condition: A driveway that’s just cracked needs a standard demo and pour. A driveway with root intrusion, a sunken corner, or a broken apron near the garage adds subgrade repair and sometimes root removal before the pour.
- Material grade: Standard broom-finish concrete is the low end. Stamped, exposed aggregate, or pavers push it up.
- Drainage corrections: If the old driveway drains toward the house, we cut and regrade for a swale or channel drain. That’s an extra few hundred to over a thousand depending on run length.
- Permit scope: A straight replacement usually falls under standard permit rules in Lakewood. Widening into the parkway or into a setback can trigger a survey and a longer approval window.
Every written estimate we hand you lists demolition, haul-off, base prep, rebar, concrete or asphalt, finish, and cleanup line by line. What typically isn’t included unless it’s called out: a new apron or approach that crosses the sidewalk (which can involve the city), drainage work, and any root removal beyond a single instance.
See the difference
Before
After
Before
After
Before
AfterWhat Lakewood Homes Specifically Do to a Driveway Job
Lakewood was built almost all at once between 1950 and 1955, and the driveways poured for those original tract homes were often 4 inches thick with no rebar or a single layer of wire mesh. Seventy years of settling, tree roots, and the daily load of modern vehicles have pushed many of them well past their service life. That’s why our driveway repair and replacement work in Lakewood so often involves tearing out a slab that was a product of 1953 rather than repairing a single bad panel.
The foundations tell the rest of the story. Lakewood tract homes sit on slab-on-grade with no basement, and the same 1950s grading and drainage patterns that worked when the houses were new now fight the mature trees, the added landscaping, and the heavier cars parked on them. In Lakewood the driveway drop from the garage floor to the street was set at a fixed pitch for the era, and when the slab settles, water pools in the apron instead of running to the gutter. That’s the first thing we check on any driveway in the 90713 and 90715 ZIP codes.
Permitting runs through the City of Lakewood, and a standard driveway replacement is straightforward: the plan check is generally quick and the inspection is on the final pour. What gets more involved is the connection to the public right-of-way, which is why we ask upfront whether the apron is part of the job. We work this same process across Lakewood and the neighboring cities of Bellflower, Hawaiian Gardens, Artesia, and Cerritos. If your driveway project lives alongside a bigger remodel, homeowners often pair this with a ADU Site Prep & Utilities in Lakewood job or a Junior ADU & Interior Conversion in Lakewood to keep one crew and one schedule. You can see the full range of where we work on our Lakewood service-area page.
Serving Lakewood, CA – Our Local Coverage Area
We serve Lakewood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Driveway Repair & Replacement in Lakewood

Most full driveway replacements take 3 to 5 working days from demo to final walk, then 48 to 72 hours of cure before you park on it. Patching and partial work can finish in a single day. Call (888) 255-8179 for a schedule based on your specific driveway.
Yes, most driveway replacements in Lakewood require a city permit, and we pull it for you as part of the job. Straight replacements are typically straightforward; widening into a setback or touching the parkway may trigger a survey or a longer review. We tell you at the estimate which category your job falls into.
Repair of a single panel or a failed section typically runs a few hundred to about $2,000, while a full driveway replacement runs $5,000 – $14,000. Concrete replacement sits at $4,500 – $12,000 and pavers run $7,000 – $18,000. Call (888) 255-8179 for an exact quote – estimates are free.
Yes. If the damage is isolated to one or two panels and the subgrade hasn’t failed, a partial replacement or spot repair is the right call. We check slope, root intrusion, and whether the surrounding slab is still sound, and we tell you which option makes sense rather than defaulting to the bigger job. The estimate will show both paths.
Every driveway repair and replacement we do is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. That’s 730 days of coverage in writing, well beyond the standard one-year workmanship warranty. We hand it over at the final walk so you have it before we pack up.
Get a Written Estimate for Your Lakewood Driveway
Call (888) 255-8179 and we’ll set up a free on-site estimate for driveway repair and replacement in Lakewood. A live person answers the phone, and we walk the driveway with you, measure it, check the subgrade and drainage, and put a line-item price in front of you before you commit. No sales push, no surprise change orders. You’ll know the number and the plan.
Written by the team at Groundwork Construction Co.












