







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Pico Rivera, CA: Cost, Timeline, and What Actually Gets Built
A chain link fence in Pico Rivera typically runs $3,500 – $9,000, with a standard 4-foot residential run of about 100 linear feet landing closer to the low-middle of that range. Most jobs are finished in one to three days once materials are on site. Galvanized steel is the default here; vinyl-coated and taller security-height runs push the number up. Call (888) 255-8179 for a free on-site estimate and a written line-item quote.
How We Build a Chain Link Fence, Stage by Stage

Chain link isn’t complicated, but it’s unforgiving of shortcuts. A fence that leans after two Santa Ana wind seasons was set wrong on day one. Here’s the real sequence.
1. Walk the line and call for utility locating (day 1)
We walk the property line with you, confirm where the fence should sit relative to the actual lot line, and mark corners, gates, and terminal posts. Before anyone digs, 811 utility locating gets called and we wait for the marks. In older Pico Rivera tracts, gas and water laterals don’t always run where you’d expect, so this step protects both the fence and the house.
2. Demo and prep (day 1)
Old fence comes out, brush and roots get cleared, and we check the grade. On a lot with a slope, the fence follows the grade in stepped panels rather than one long diagonal line. If concrete is being cut or a curb removed, that happens here. You decide at this point whether the old posts stay or go; on most jobs they go.
3. Post setting (day 1 – 2)
Holes get dug to depth, posts set plumb, and concrete poured around each one. Terminal posts, corner posts, and gate posts get larger footings and deeper burial than line posts because they carry the tension. Concrete needs to cure before the fabric goes up, which is why a two-day job is common and a one-day job usually means small runs or repair work.
4. Rails, tension, and fabric (day 2 – 3)
Top rail goes in, tension bands and turnbuckles get set, and the chain link fabric is stretched and tied off. This is where the difference between a tight fence and a sagging one lives. You’ll walk the line with us before we call it done, and we tension anything that doesn’t read right.
5. Gates and final walkthrough (day 3)
Gate frames get hung, latches and hinges checked, and the gate swing adjusted so it clears the ground and latches clean. On most jobs we’re done in a single visit once the posts have cured. Everything we build carries our 730-Day Done Right Promise: if it isn’t right, we come back and make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
Chain link is a small set of decisions, but each one moves the price and the lifespan.
- Gauge of the fabric and framework. Residential chain link is commonly sold in lighter and heavier wire gauges, and the framework (top rail, posts, tension bands) comes in different wall thicknesses. Heavier gauge costs more up front and holds its shape far longer in wind. On a windy corner lot, going heavier is the right call.
- Galvanized vs. vinyl-coated. Bare galvanized steel is the cheapest and hides scratches well. Vinyl-coated (black or green) costs more, looks cleaner against stucco, and adds a layer of corrosion protection. A lot of Pico Rivera homeowners pick black-coated for the street-facing run and galvanized for the back line.
- Height. 4-foot is standard residential. 5 and 6-foot runs cost more per linear foot and often trigger a conversation about permits and sight lines with neighbors.
- Gates. Walk gates and drive gates are priced separately. A double drive gate with a heavier frame is the single biggest line-item swing on most jobs.
- Post setting. Concrete-set posts in the ground are standard. Surface-mounted posts on existing concrete cost more in hardware but save the digging.
If the fence is one piece of a bigger yard project, homeowners often pair this with Concrete Driveways & Concrete Work in Pico Rivera or Asphalt Driveways & Resurfacing in Pico Rivera, since the crew and the equipment are already on site and the gate alignment gets sorted in one pass.
What a Chain Link Fence Costs in Pico Rivera, CA

The honest range for a residential chain link fence in Pico Rivera is $3,500 – $9,000. Where you land depends on five things:
- Linear footage. The single biggest driver. A typical 1950s – 60s tract lot in Pico Rivera has a perimeter in the 150 – 220 foot range once you account for the front, sides, and back.
- Height and gate count. A 6-foot run with a double drive gate sits at the top of the range. A 4-foot run with one walk gate sits near the bottom.
- Existing fence condition. Concrete footings from an old fence, roots, or a fence half-buried in soil all add demo and prep time.
- Grade and access. A flat lot with a clear path to the back is fast. A tight side yard, a slope, or a fence line that runs behind a detached garage adds labor.
- Permit scope. A straight replacement along an existing line usually needs less paperwork than a new line or a height increase. We pull permits and pass inspections as part of the job.
A written estimate from us is line-item: footage, gauge, height, gate count, post setting, demo, and permit cost. What’s typically not included: hauling off a fence that was buried in concrete (quoted separately if needed), utility locating delays, or moving sprinkler lines that run along the fence path. Upfront pricing, no surprises: the number you see is the number you pay. Call (888) 255-8179 and we’ll get you an exact quote.
See the difference
Before
After
Before
After
Before
AfterWhat Pico Rivera Homes Specifically Do to This Job
Pico Rivera is a built-out, post-war working-class suburb. Most of the single-family homes here went up in the 1950s and ’60s, which means almost every fence job we quote on these streets is a replacement, not a new build. The typical lot is a small three-bedroom stucco house on a gridded street, and the fence line has usually been moved, patched, or replaced at least once by a previous owner. That history matters: we regularly find old concrete footings, buried sprinkler lines, and fence posts set into what used to be a planter box. In the 90660 ZIP codes, the back line often runs behind a detached garage, so gate placement and access need to be walked before anything gets dug.
Permitting for a fence in Pico Rivera follows LA County practice: a straight like-for-like replacement along an existing line is often exempt, but a new fence line, a height increase, or a fence near a corner with sight-line requirements can trigger a permit and inspection. We check that before a shovel hits the ground. The dry Santa Ana winds that come through in fall put real load on fence panels, which is why we set terminal posts deeper and use heavier gauge on west-facing runs. If you want the full picture of everything we install in this city, our Fence Installation in Pico Rivera page covers the wider scope, and you can see the broader Fence Installation service we offer across the region.
Serving Pico Rivera, CA – Our Local Coverage Area
We serve Pico Rivera and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Chain Link Fence in Pico Rivera

Most residential chain link fence jobs take one to three days once materials are on site. Day one is demo, layout, and post setting; day two or three is fabric, rails, and gates after the post concrete cures. Call (888) 255-8179 for a timeline on your specific lot.
A straight replacement along an existing fence line usually does not require a permit, but a new line, a height increase above standard residential, or a corner lot with sight-line rules can trigger one. We check the requirement for your address and pull any permits and inspections as part of the job.
Expect $3,500 – $9,000 for a typical residential run in Pico Rivera, with footage, height, gauge, and gate count driving the swing. Call (888) 255-8179 for an exact quote; estimates are free and written line-item.
In most cases yes. We call for utility locating before digging, and we walk the sprinkler layout with you beforehand so post holes get set between lines wherever possible. If a sprinkler line sits directly on the fence path, we flag it before we dig and quote any rerouting up front rather than after.
Every chain link fence we build is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right, for two full years. Calls are answered by a live person 24/7, and our technicians arrive background-checked and in uniform.
Get a Free Chain Link Fence Estimate in Pico Rivera
We’ll walk your property line, measure the footage, check the grade and gate locations, and hand you a written line-item estimate for your chain link fence in Pico Rivera. No pressure, no vague numbers. Call (888) 255-8179 to schedule your free on-site estimate, and a real person will pick up, any hour, any day. You can also start with our Pico Rivera service page to see everything we handle in this city.
Written by the team at Groundwork Construction Co.












