







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Metal Roofing in Santa Fe Springs: What It Costs and How Long It Takes
Metal roofing in Santa Fe Springs typically runs $15,000 to $40,000 installed, and a standard single-story ranch home here usually takes 3 to 6 days from tear-off to final inspection. The price holds heavy because most 90670 homes need structural work before a single panel goes down, and because a metal roof is meant to outlast everything else on the house. Call (888) 255-8179 and we’ll walk your roof and give you a line-item number, not a ballpark.
From Tear-Off to Final Inspection: How We Run a Metal Roofing Job

Metal roofing isn’t a two-day job, and the crew that treats it like one will cut corners you can’t see until year five. Here’s the actual sequence we run in Santa Fe Springs.
Day 1: Tear-off and deck inspection
We strip the old roofing to bare deck, then spend the first morning on our hands and knees checking every sheet for rot, soft spots, and old water damage. On a 1950s ranch this is where we find the surprises: a roof deck that’s been patched three times over the decades, or sheathing that’s thinner than modern code expects. The homeowner decides that morning whether to replace bad decking or patch it. Replacing is the right call almost every time.
Late Day 1 to Day 2: Underlayment, flashing, and substrate
Once the deck is sound we lay the high-temp underlayment and set the eave and valley flashing. This is the stage that determines whether the roof leaks in ten years, so we don’t rush it. For homes near the 5/605 interchange, we pay close attention to counter-flashing at chimneys and walls, where blowing dust and wind-driven rain find weak points.
Day 2 to Day 4: Panel installation
Panels go down in runs, fastened to manufacturer spec with the correct clips and closures. For concealed-fastener systems, the panel orientation and clip spacing is what carries the Santa Ana wind rating, and we don’t eyeball it. The homeowner confirms panel profile and color at this point if it wasn’t locked in earlier. A steep or complex roof with hips and dormers adds a day here.
Day 4 to Day 5: Ridge, trim, ventilation, and penetrations
Ridge caps, rake trim, and every pipe boot and vent get finished out. We also install or upgrade ridge and eave ventilation so the attic breathes properly, which matters in Santa Fe Springs heat. Most jobs are complete within a single working week at this stage for a straightforward ranch home.
Final stage: City inspection and walkthrough
We call the inspection, meet the inspector on site, and walk the finished roof with you. You get the written 730-Day Done Right Promise in hand, and if anything’s not right, we come back and make it right. No warranty fine print to argue about later.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Metal Roofing Choices: What You’re Actually Picking Between
- Standing seam steel: the top-end choice, $22,000 to $40,000 on a typical Santa Fe Springs roof. Concealed fasteners, no screws to back out, and the longest service life. Best for homeowners who plan to stay put and want to stop thinking about the roof.
- Exposed-fastener metal panels (screw-down): $15,000 to $24,000. Cheaper and installed faster, and it handles a shed or simple gable roof well. Trade-off is visible fasteners with washers that need checking and occasionally re-seating every several years.
- Stone-coated steel tile: $20,000 to $35,000. Looks like clay tile, weighs far less, and locks down tight in wind. It suits Santa Fe Springs homes that want a tile look without the structural reinforcement tile demands.
- Panel gauge: 26-gauge is the residential standard and holds up fine in this climate. 24-gauge costs more and takes a hit better, which matters on roofs with foot traffic or near trees.
- Kynar 500 finish vs standard paint: Kynar-class coatings resist the intense inland sun and hold color for decades. Standard paint is cheaper but fades faster under Santa Fe Springs summer UV.
- Color and profile: barring an HOA restriction, the pick is yours. A low-slope profile on a flat-ish section is fine; the steeper the pitch, the more visible the rib pattern.
What Metal Roofing Costs in Santa Fe Springs, CA

Expect $15,000 to $40,000 installed for a typical single-story home here, with most jobs landing in the $20,000 to $30,000 range. The number is driven by a handful of real variables.
Roof size and complexity. A plain gable roof on a 1,200 sq ft ranch is the low end. Hips, dormers, multiple plane changes, and valleys all add labor and material.
Existing condition. A single layer of composite comes off cheap. Multiple layers, rotted sheathing, or a roof that was patched over old water damage pushes the number up fast – often $2,000 to $6,000 in deck and structure repairs.
Panel system choice. Exposed-fastener panels sit at the bottom of the range; standing seam and stone-coated steel sit at the top.
Permits and inspection scope. A straightforward re-roof permit runs a few hundred dollars and one inspection. Structural reinforcement or a re-deck can expand that.
Ventilation and extras. Adding ridge and eave ventilation, upgrading to a solar-ready underlayment, or addressing an old chimney all get added in.
Our written estimate includes deck repair line items, underlayment, flashing, panels, trim, ventilation, permit, and cleanup. It does not include structural engineering if the deck inspection turns up a beam problem – we quote that separately once we see it.
See the difference
Before
After
Before
After
Before
AfterWhat Santa Fe Springs Roofs Throw at You
Santa Fe Springs is a working town with homes tucked beside industry, and that shapes this job more than anything else. The 1940s to 1970s ranch homes on small lots along the residential pockets near the 5 and 605 often still carry original roof structures, and we routinely find undersized fascia and worn sheathing under a single layer of 30-year shingles that’s already sagging. The dusty, truck-traffic-heavy environment on homes near the freeway and rail yards accelerates coating wear, so a metal roof’s factory finish is a real upgrade over repainting composite every few years. Inland summers bake these roofs, and Santa Ana winds in fall test every clip and fastener. The regional seismic provisions also mean anything we tie into or reinforce on the structure gets done to code.
Serving Santa Fe Springs, CA – Our Local Coverage Area
We serve Santa Fe Springs and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked About Metal Roofing in Santa Fe Springs

A typical single-story Santa Fe Springs home takes 3 to 6 working days. Complex roofs with hips, dormers, or significant deck repair run toward the longer end, and we tell you which at the estimate.
Yes, a re-roof permit is required, and the work gets inspected by the city. We pull the permit, schedule the inspection, and meet the inspector on site so you’re not chasing paperwork. Call (888) 255-8179 if you have permit questions specific to your street.
In most cases yes. A re-roof replaces what’s on top of the deck, not what runs through it. If we find rotted sheathing or a beam that needs attention, we quote that separately before proceeding.
Most jobs land between $15,000 and $40,000 installed, with the low end being exposed-fastener panels on a simple roof and the high end being standing seam or stone-coated steel with deck repairs. Call for an exact quote – estimates are free.
All our projects carry the 730-Day Done Right Promise – if it’s not done right, we make it right. Manufacturer finish and panel warranties stack on top of that, and we hand you the paperwork at the final walkthrough.
If you’re weighing a metal roof against a full replacement or pairing it with other exterior upgrades, our Roofing team handles the wider project, and homeowners often pair a re-roof with Window Replacement in Santa Fe Springs to close the envelope at once. We cover the whole Santa Fe Springs area, and where the work is part of a full Roofing in Santa Fe Springs scope, we sequence it together. Homeowners often pair exterior upgrades with Impact Windows & Doors in Santa Fe Springs when they want wind-rated openings to match a wind-rated roof.
Get a Free Metal Roofing Estimate in Santa Fe Springs
Call (888) 255-8179 for a free on-site estimate. We’ll inspect the deck, check for old water damage, talk through panel options, and hand you a written line-item price with no change orders. A live person answers around the clock, and if you’re tackling other exterior work we’ll sequence it into one plan.
Written by the team at Groundwork Construction Co.












