







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in South Whittier, CA: What It Costs and How Long It Takes
A tub-to-shower conversion in South Whittier typically runs $3,500 to $10,000 and takes 3 to 7 working days once the materials are on site. The job means pulling the old tub and its surround, reframing and waterproofing the alcove, setting a new shower pan, tiling the walls, and reconnecting the drain and valve trim. Call (888) 255-8179 for a free on-site estimate before you decide anything.
How a Tub-to-Shower Conversion Actually Runs, Stage by Stage

Most contractors wave their hands at the schedule. Here’s the real one, with the decision points marked so you know what you’re signing up for.
Stage 1 – Measure and confirm the layout (day 0, about an hour). We measure the alcove, check whether the existing drain is centered or offset, and confirm the wall framing behind the tile. You decide here whether the new shower keeps the tub’s footprint or shifts a few inches. That single choice drives cost more than almost anything else.
Stage 2 – Demo and haul-out (day 1). The tub, surround, valve trim and any drywall come out. In South Whittier’s older homes we usually find that the wall behind the tub is original drywall, sometimes with old moisture staining at the base. Nothing goes back until that’s addressed.
Stage 3 – Plumbing, electrical and rough-in inspection (day 1 into day 2). The drain gets repositioned if needed, the valve cartridge is replaced, and the shower gets its rough framing and blocking for grab bars or a bench. If we change the drain location or add a light or fan, this is the stage where a county inspector comes out. You approve fixture placement before the walls close up.
Stage 4 – Waterproofing and tile (days 2 through 5). A bonded waterproofing membrane goes over cement backer board, corners and the curb get their proper seals, and thin-set and tile follow. A 24-hour flood test on the pan happens before tile. This is the slowest stretch and the one worth being patient with; rushing waterproofing is how showers leak a year later.
Stage 5 – Glass, trim, sealant and walkthrough (days 6 and 7). The shower door or curtain rod goes in, the valve trim gets set, and we seal every joint with a mold-resistant silicone. You do a wet test with us before we pack up. The whole project is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Make Before Demo Day
Every tub-to-shower conversion comes down to five decisions. Here’s the honest trade-off on each.
- Shower pan type. A pre-formed acrylic or fiberglass pan is the fastest install and the most forgiving on an uneven slab, but it looks like a pan. A tiled mud-set or foam pan costs more and adds a day, and it’s what you want if the rest of the room is tile.
- Wall material. Acrylic surrounds are waterproof, wipe clean, and land at the low end of the range. Porcelain or ceramic tile gives you design freedom and holds value, with a grout maintenance cost over time. Large-format panels split the difference.
- Tile and grout grade. Standard ceramic is budget-friendly; porcelain and rectified formats cost more per square foot but wear better on high-traffic showers. Epoxy grout costs a bit more and resists staining far better than cement grout.
- Glass. A framed sliding door is the practical choice. Frameless tempered glass is the upgrade most homeowners pick, and it’s what makes a modest conversion look like a real remodel. Either way it’s tempered safety glass.
- Fixtures and finish. A basic pressure-balance valve is standard. A thermostatic valve or a handheld-plus-rain combo pushes the price up. Brushed nickel and matte black tend to cost a little more than chrome. Kohler and similar lines are what most of our South Whittier customers choose, and we can spec the trim to match.
What Tub-to-Shower Conversion Costs in South Whittier, CA

Plan on $3,500 to $10,000 for the conversion. A straightforward swap keeping the existing drain location and using an acrylic pan with a tiled or panel wall sits near the bottom. Moving the drain, upgrading glass, and tiling the full alcove in porcelain pushes toward the top.
The five variables that move the number:
- Alcove size. A standard 60-inch tub alcove is the baseline. A wider or irregular opening needs custom work.
- Existing condition. Water damage, soft framing, or old galvanized drain lines add repair time and money before any new tile goes in.
- Plumbing and electrical relocation. Keeping the drain and valve where they are saves real money. Moving them means opening walls and, in most cases, an inspection.
- Material grade. Acrylic and ceramic at the low end, porcelain and frameless glass at the high end. A $2,000 swing covers a lot of that spread.
- Permit scope. A like-for-like swap often needs no permit. Moving plumbing or electrical does, and that’s a real line item.
A written estimate from us itemizes demo, disposal, rough-in, waterproofing, tile or panel material, glass, fixtures, labor and permit fees. It also lists what’s not included – usually structural repair if rot shows up after demo, and moving a toilet or vanity, which belongs to a wider project. If the conversion is part of a larger renovation, see our Bathroom Remodeling in South Whittier page for the full scope, and our Bathroom Remodeling service for how we handle the wider room.
See the difference
Before
After
Before
After
Before
AfterWhat South Whittier Homes Do to This Job
South Whittier is an unincorporated pocket of LA County, and that changes the paperwork. Plans and permits go through LA County Public Works rather than a city building department, so inspection scheduling runs on county timelines that differ from Whittier, Santa Fe Springs or La Mirada next door. We plan for that rather than promise a date that county scheduling controls.
The housing stock matters just as much. Most of the homes here are 1940s to 1960s single-story stucco tract houses on generous 6,000 to 8,000 square foot lots, and many still have early two-wire electrical and older plumbing behind the tile. When we open a tub alcove in South Whittier, we regularly find the drain is original cast iron or galvanized steel, sometimes with a slow seep at the trap. Bringing that up to current code is not optional if we’re changing the drain. It’s the most common surprise line on a South Whittier tub-to-shower conversion, and we’d rather you hear it now. Our technicians have up to 12 years of experience and we’re licensed, insured and bonded, so the work is done right and the paperwork is handled. We cover all of South Whittier and the surrounding area.
Serving South Whittier, CA – Our Local Coverage Area
We serve South Whittier and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Tub-to-Shower Conversion in South Whittier

Most tub-to-shower conversions take 3 to 7 working days from demo to walkthrough, plus material lead time. The demo and rough-in happen on day one, waterproofing and tile take several days, and glass and trim close it out. Call (888) 255-8179 for a schedule built around your specific setup.
A like-for-like swap in the same footprint often needs no permit, but moving the drain, valve or electrical requires one, and in South Whittier that permit comes from LA County Public Works, not a city office. We confirm the scope and pull permits where required and see the inspection through. Call (888) 255-8179 to talk through your project.
Yes, in most cases. If the existing drain is centered or close to it and the valve stays in place, we can build the new shower over the same footprint with no plumbing relocation – which keeps the cost near the low end of the $3,500 to $10,000 range. Call (888) 255-8179 for a free estimate and a straight answer on whether yours qualifies.
Expect $3,500 to $10,000 depending on pan type, wall material, glass, and whether the plumbing or electrical moves. An acrylic panel shower with a framed door sits near the bottom; full porcelain tile with frameless glass and relocated drains sits near the top. Call (888) 255-8179 for an exact quote – estimates are free.
Every conversion is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right – with no fine print and no shortened coverage. That includes the waterproofing, tile and fixture work. Call (888) 255-8179 and we’ll walk you through what’s covered.
Get a Free Tub-to-Shower Conversion Estimate in South Whittier
Call (888) 255-8179 and a live person answers, day or night. We’ll schedule a free on-site estimate, measure your alcove, talk through pan and tile options, and hand you a written, itemized quote with no surprises – the number you see is the number you pay. If a wider renovation is on your list, homeowners often pair this with new exterior work like Metal Roofing in South Whittier or Tile Roofing in South Whittier. We also offer 0% financing for 18 months and $1,000 off projects over $10,000.
Written by the team at Groundwork Construction Co.












