







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Downey, CA: What the Job Actually Involves
A chain link fence in Downey usually runs $3,500 to $9,000 installed, and most residential yards are done in 2 to 4 working days once we’ve marked utilities and pulled any permit the city requires. That range covers a typical 100 to 200 linear-foot run at 4 to 6 feet tall with posts set in concrete. Call (888) 255-8179 for a free on-site estimate, and we’ll give you an exact number based on your actual lot line, not a phone guess.
From String Line to Stretched Fabric: How a Chain Link Fence Goes In

Chain link is one of the most forgiving fences to install and one of the easiest to get wrong. The variables that matter are grade, plumb, post depth, and tension, and each one gets decided at a specific stage. Here’s the sequence we run on a Downey job.
Day 1 morning: walk the line and mark utilities
Before anyone digs, we stake the fence line with you and confirm the property boundaries, then call 811 to have underground utilities marked. This is non-negotiable in a built-out suburb like Downey, where older lots often have gas, water, irrigation, and old sewer laterals running close to the sidewalk. If a post lands on a sprinkler line or a buried conduit, we shift that post. You decide the exact height and where the gate drops before a shovel hits the dirt.
Day 1 afternoon: demo and set posts
If you have an old fence, we pull it and haul it off. Then we set terminal posts (ends, corners, and gate posts) in concrete first, because those carry the tension. Line posts go in at 8 to 10 feet on center, set below the frost line equivalent for our mild winters (typically 24 to 30 inches deep in Downey soil). Concrete cures overnight, sometimes longer on a hot day. You don’t have to decide anything here; this stage is on us, and it’s the one that determines whether the fence stays tight for the next 20 years.
Day 2: top rail, tension wire, and fabric
Once the concrete has set, we run the top rail through the post caps, add a bottom tension wire or bottom rail depending on your spec, and stretch the chain link fabric. The fabric gets pulled tight with a come-along and tied off at every post. This is where a cheap install shows: loose fabric sags at the bottom within a year. We tension to a spec, not to “good enough.”
Day 3: gates, hardware, and walkthrough
Gate frames get set, hinges and latches installed, and we check the swing and latching. We walk the entire fence with you, point out anything you want adjusted, and clean the site of all offcuts, wire ties, and concrete debris. On a larger yard with multiple gates or a slope, this stage can spill to Day 4.
Inspection and permit closeout
Some Downey fence work requires a permit, and some doesn’t. Height is the usual trigger: a fence over 6 feet or a fence in a front setback often needs a permit and an inspection in this city. We handle the permit pull and the inspection scheduling. You don’t chase the city, we do.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
Chain link isn’t one product. Here’s what a Downey homeowner is really deciding.
- Gauge of wire. 11.5 gauge is the standard residential weight; 9 gauge is thicker and much harder to bend or cut, which matters if security is the point. 9 gauge costs roughly 20 to 30 percent more on the fabric portion.
- Height. 4 feet is common for a boundary line; 5 feet reads more private; 6 feet is the tallest most Downey residential lots can go without a use permit and neighbor questions. Going above 6 feet usually requires extra approval.
- Coating. Galvanized steel is the baseline and the cheapest. Vinyl-coated (green or black) costs a bit more but blends into landscaping and resists our dry-summer fade and smog better over 15 to 20 years.
- Post material. Standard 2-inch galvanized posts are fine for flat runs. Heavier Schedule 40 posts suit gate posts and wind-exposed corners.
- Gates. A 4-foot walk gate versus a 10 to 12-foot double drive gate changes the hardware, the footer size, and the price. Drive gates need deeper, wider concrete footings to stop sag.
- Top rail versus tension wire only. A top rail is the cleaner look and adds rigidity; tension wire only is cheaper and fine for tall, straight runs.
Brands like CGI and CWS are worth mentioning here because they make the coated wire and fittings a lot of Downey jobs end up using, and both hold up to the long dry season.
What a Chain Link Fence Costs in Downey, CA

Plan on $3,500 to $9,000 for a typical residential run. Where you land in that range depends mostly on these variables:
- Linear footage. A 100-foot side yard sits at the low end; 200 feet wrapping the back and both sides pushes toward the high end.
- Height and gauge. Stepping from 4 feet to 6 feet with heavier 9 gauge fabric adds roughly $800 to $2,000 on a mid-size job.
- Gates. Each walk gate adds a few hundred; a drive gate with proper footings adds more because of the concrete and hardware.
- Demo and haul-away. Removing an existing wood or rusted chain link fence with concrete footings adds labor and disposal cost. Fresh dirt is cheaper than old fence.
- Site difficulty. Slopes, tight side yards, root systems, and posts that hit buried utilities or old footings all add time. Downey’s tight lots make this a real line item.
Your written estimate will itemize footage, gauge, posts, concrete, gates, demo, permit, and haul-away. The number you see is the number you pay. We don’t do change orders after the fact.
See the difference
Before
After
Before
After
Before
AfterWhat Downey Homes Specifically Do to This Job
Downey is a built-out, largely post-WWII inner-ring suburb, which changes fence work in a way it doesn’t change new construction on open land. Most fencing here is going onto 1940s to 1960s tract lots with tight property lines, established landscaping, and buried utilities that show up exactly where a post wants to go. On older tracts around Furman Park and the original 1950s Downey ranch neighborhoods, we routinely find old irrigation lines, shallow buried stubs, and concrete footings from a previous fence still in the ground, and those have to be cored or relocated before a new post can set. The city’s plan-check reality also matters: Downey’s approval culture leans toward preserving the look of its historic ranch tracts, so a fence that reads too tall or too industrial at the front can trigger a neighbor complaint or a city review. Add hot inland summers that burn the marine layer off by late morning and stretch concrete cure times, and we schedule pours early. If your project grows into a full boundary or landscape rebuild, it’s often part of a Fence Installation in Downey plan, and homeowners often pair this with Concrete Driveways & Concrete Work in Downey when the front gate and apron get redone at the same time.
Serving Downey, CA – Our Local Coverage Area
We serve Downey and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Downey

Most residential chain link fences in Downey are done in 2 to 4 working days, with a larger yard or multiple gates going to 4 or 5. Concrete cure time extends the schedule, so the first day is posts, and the last is stretch and walkthrough. Call (888) 255-8179 for a job-specific timeline.
Often yes when the fence exceeds 6 feet or sits in a front setback. We check the requirement for your lot, pull the permit if needed, and handle the inspection. You don’t have to navigate the city yourself; we do it as part of the job.
In most Downey yards yes, because chain link posts are small-diameter and set at 8 to 10 foot spacing rather than poured as a continuous footing. When a post hits an old line, we shift it or sleeve it. We always mark utilities first, so buried plumbing and gas lines get protected before we dig.
Expect $3,500 to $9,000 for a typical residential run, with height, gauge, footage, gates, and demo pushing the number. Call (888) 255-8179 for an exact quote; estimates are free and we walk the line with you.
Our workmanship is covered by our 730-Day Done Right Promise, which means if anything we installed is wrong, we make it right. We stand behind the install for two full years, longer than most fence contractors offer, and we put that in writing.
Get a Free Chain Link Fence Estimate in Downey
Call (888) 255-8179 and a live person answers, any hour, any day. Tell us the footage and the height you have in mind, and we’ll set a time to walk your line and give you a written, itemized estimate. We cover Downey and the surrounding area, and every job is backed by the 730-Day Done Right Promise. For the broader scope, our Fence Installation service handles the full project, and homeowners also pair their fence with Asphalt Driveways & Resurfacing in Downey when the driveway needs a refresh. Financing is available at 0% for 18 months, plus $1,000 off projects over $10,000.
Written by the team at Groundwork Construction Co.












