







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Walk-In Showers & Shower Remodeling in Lakewood, CA: What the Job Actually Involves
Walk-in showers & shower remodeling in Lakewood, CA usually cost between $9,000 and $28,000, with most single-shower projects landing in the $4,500 – $12,000 range when the footprint stays put. A straightforward shower replacement runs about 2 to 3 weeks from demo to final inspection; moving plumbing or changing the footprint pushes it to 4 to 6 weeks. Call (888) 255-8179 for a free on-site estimate and a written, line-item quote before anything gets torn out.
How We Run a Walk-In Shower Project, Start to Finish

Every Lakewood walk-in shower follows the same five stages. The order matters more than the schedule, because skipping a step here is how showers end up leaking into a slab two years later.
Stage 1: Site visit and scope (day 1, about 90 minutes)
We measure the existing shower or tub alcove, check the valve and drain locations, and look at what’s behind the wall. In a 1950s Lakewood tract home, that often means opening a small inspection cut to see whether the original galvanized supply lines or cast-iron drain are still in place. You decide the footprint at this stage: keep the existing rough-in or relocate the drain and valve. Keeping it is cheaper and faster by a wide margin.
Stage 2: Demo, rough-in, and inspection (days 2 – 4)
We tear out the old pan, tile, and backer, then inspect the subfloor and framing for water damage. Any plumbing or electrical change gets roughed in and inspected before the walls close. This is where a permit adds 2 to 5 business days to the calendar, and it’s not optional once you move a drain or add a valve.
Stage 3: Waterproofing (days 4 – 6)
We build the pan, slope it to the drain, and apply a bonded waterproofing membrane over cement board on the walls. Waterproofing cures for roughly 24 hours before tile goes up. You don’t decide much here, but you should ask to see the flood test before tile starts. We walk you through it.
Stage 4: Tile and glass (days 7 – 12)
Tile set, grout, and cure take about 3 days. Glass gets templated after tile is complete and installed 5 to 10 business days later, so a frameless enclosure usually lands at the tail end of the schedule. This is where material choices you locked in during the estimate show up in the finish.
Stage 5: Fixtures, final inspection, walkthrough (days 12 – 18)
We install the shower head, valve trim, drain cover, and any bench or niche accessories, then run the final plumbing inspection. A walkthrough with you covers the caulk lines, drain flow, and the care sheet for the tile and glass. Then the job is closed.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Shower Options You’ll Actually Choose Between
Most of the decision-making in a walk-in shower project comes down to four or five real forks. Here’s what each one costs you in money, maintenance, or longevity.
- Acrylic or fiberglass pan vs. tiled mud-set pan. A prefab pan runs less and installs in a day. A tiled pan adds roughly $1,200 – $2,500 to the job but lets you match the floor tile and control the slope exactly. In a slab-on-grade Lakewood home, a tiled pan with a proper membrane is the longer-lived choice.
- Porcelain vs. natural stone tile. Porcelain (large-format, 12×24 or 24×48) is denser, easier to seal, and the default for wet walls. Natural stone like marble or travertine looks warmer but needs sealing every 12 to 18 months, and in a shower that’s real maintenance.
- Frameless glass vs. framed or semi-frameless. Frameless glass costs $1,500 – $3,500 for a walk-in and reads cleaner; framed glass runs $600 – $1,200 and hides a slightly out-of-square opening, which is common in original 1950s walls.
- Curbless vs. curbed entry. A curbless entry (often called zero-threshold) is safer and easier to clean but requires recessing the floor or building up the surrounding floor, which adds to the plumbing and framing scope. A curbed pan is simpler and cheaper.
- Linear drain vs. center drain. A linear drain lets you use larger-format tile with a single slope and hides the drain line; a center drain is standard and costs less. Linear drains add roughly $400 – $1,000 depending on finish.
- Prefab modular enclosure vs. custom tile. A modular enclosure runs cheaper and installs in 2 – 3 days but locks you into stock sizes. Custom tile gives you exact fit in a narrow Lakewood alcove where nothing stock fits cleanly.
We carry a curated line of material partners across the trade, so the tile, valve, and glass come from names you recognize rather than whatever’s on the shelf that week.
What Walk-In Showers & Shower Remodeling Costs in Lakewood, CA

Walk-in showers & shower remodeling in Lakewood run $9,000 – $28,000 for a full shower rebuild inside a bathroom remodel scope, with a shower-only replacement landing at $4,500 – $12,000 and a walk-in install at $3,500 – $10,000 depending on what’s being torn out. Here’s the line-item view:
| Item | Typical Range |
|---|---|
| Walk-in shower installation (replacing a tub) | $4,500 – $12,000 |
| Shower replacement (same footprint, new tile and pan) | $3,000 – $8,500 |
| Tub-to-shower conversion | $3,500 – $10,000 |
| Frameless glass enclosure (add-on) | $1,500 – $3,500 |
| Vanity (where it’s part of the same scope) | $800 – $3,000 |
The four variables that push the number up: footprint changes (moving the drain or valve adds plumbing, rough-in, and inspection time), existing water damage (rotted subfloor or framing behind old tile), material grade (natural stone and custom glass sit at the top), and permit scope (a shower replacement inside the existing footprint may not need a permit; moving plumbing or electrical does, and adds inspection days).
A written estimate from us lists demo, framing repairs, waterproofing, tile labor and material, fixtures, glass, and inspection costs line by line. What it won’t include unless we say so: asbestos or lead abatement on pre-1980 materials, structural repairs found after demo, and HOA submittal fees. We don’t change the number once the job starts unless you approve a change order in writing. That’s the upfront pricing commitment, and it’s backed by our 730-Day Done Right Promise on the workmanship.
See the difference
Before
After
Before
After
Before
AfterWhat Lakewood’s 1950s Tract Housing Does to This Job
Nearly every Lakewood shower we open looks the same inside the wall. Lakewood was built almost entirely between 1950 and 1955 as one of the first planned post-WWII communities, and most of those homes were wood-frame stucco on a concrete slab with cast-iron drains and galvanized supply lines. That means a shower remodel here is almost always a retrofit. Around the Mayfair and Lakewood Park tracts, we regularly find the original cast-iron drain under the shower pan is pitted to the point of failure, and the galvanized supply to the valve has lost half its interior diameter. Both get replaced during rough-in while the wall is open, because going back in later costs three times as much.
The city’s permitting process runs through the Building and Safety division, and any drain relocation or valve change requires a plumbing permit with a rough-in inspection. Because every house on the block shares the same 1950 slab and framing plan, a given scoping fix that passes on one home usually passes on the next, which shortens the plan-check turnaround compared to a custom build. And the size reality is unavoidable: most of these homes are three-bed, one-bath, roughly 1,100 square feet, so a shower remodel often doubles as a small-bathroom remodel scope. If the project grows into a full bath-and-vanity redesign, that’s where our Bathroom Remodeling in Lakewood page covers the wider project, and our Bathroom Remodeling service hub has the full service list. We also cover Lakewood and the surrounding cities, including Bellflower, Hawaiian Gardens, Artesia, and Cerritos.
Two adjacent jobs tend to come up while we’re on site at these homes: the moisture cycling through original single-pane windows and 70-year-old roof framing is the reason homeowners often pair this with Roof Replacement & Installation in Lakewood or a longer-life option in Metal Roofing in Lakewood. Same stucco skin, same era, different trade.
Serving Lakewood, CA – Our Local Coverage Area
We serve Lakewood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Walk-In Showers & Shower Remodeling in Lakewood

A shower replacement in the same footprint takes about 2 to 3 weeks; a walk-in install that relocates the drain or changes the layout runs 4 to 6 weeks once permits and inspections are in the schedule. Glass templating adds 5 to 10 business days after tile, so build that into the plan. Call (888) 255-8179 to get a firm timeline for your specific bathroom.
You need a plumbing permit if the drain or valve is being moved or replaced, and an electrical permit if you’re adding a light or fan inside the shower. A tile-and-pan replacement over the existing rough-in usually doesn’t trigger a permit. We pull the permits and manage the inspections, so nobody’s asking you to chase a plan checker.
Yes, and it’s the most common scope we run. Keeping the drain and valve where they are saves $2,000 – $4,000 in plumbing and 1 to 2 weeks of inspection time. You still get the new pan, waterproofing, tile, glass, and fixtures. If the existing rough-in is sound, this is the cheaper path and we’ll tell you so up front.
A walk-in shower or shower rebuild in Lakewood runs $3,500 – $12,000 depending on footprint and material, with full walk-in showers & shower remodeling inside a bathroom scope landing at $9,000 – $28,000. Linear drains, natural stone, and frameless glass push the top end. Call (888) 255-8179 for a written estimate, free on site.
Every walk-in shower project is covered by our 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If anything we built fails, we make it right. Fixture and glass manufacturer warranties ride on top of that for the product side of the install.
Get Your Free Walk-In Shower Estimate
When you call (888) 255-8179, a live person answers around the clock and books a free on-site estimate at your Lakewood home. We walk the bathroom, measure the alcove, check what’s behind the wall, and leave you with a written line-item quote. You’ll see exactly what the number covers and what it doesn’t. No change orders, no surprises. You also qualify for $1,000 off projects over $10,000 and 0% financing for 18 months. Estimates are free. The number you see is the number you pay.
Written by the team at Groundwork Construction Co.












